One step prepared Janus acid-resistant nanofiltration membranes with opposite surface charges for acidic wastewater treatment

Ling Yu,Yong Zhang,Lili Xu,Qinyi Liu,Baoleerhu Borjigin,Deyin Hou,Jun Xiang,Jun Wang
DOI: https://doi.org/10.1016/j.seppur.2020.117245
IF: 8.6
2020-11-01
Separation and Purification Technology
Abstract:<p>In order to enhance the membrane separation efficiency of multivalent metal ions and acid, high performance Janus acid-resistant nanofiltration membranes (NFMs) with opposite charge properties (selective layer) were fabricated by polyethyleneimine (PEI) and cyanuric chloride (CC) via interfacial polymerization. A novel and facile method (named LC-CT) was developed to obtain the Janus acid-resistant NFMs in one step, by controlling the organic phase (CC) concentration to be low followed by the curing treatment. It was found that CC concentration had a significant effect on the charge property of the membrane surface. Low CC concentration endowed a loose selective layer with many unreacted –NH<sub>2</sub> on the flip side while curing treatment attributed to the less defective layer. Thus, LC-CT method endowed the membrane Janus property with high salt rejection and flux. The new generated Janus NFMs exhibited better acid stability than NFM-1 (commercial, polyamide), and higher MgCl<sub>2</sub> rejection than NFM-1 and NFM-2 (commercial, acid-resistant) after soaking in 3 wt% HCl at 25℃ for 1800 h or 50℃ for 72 h. Also, the flux of this polyamine Janus NFM was 4.2 ∼ 19 times higher than that of previous reported polyamine acid-resistant NFMs, which indicated a good application potential of this membrane in acidic wastewater treatment.</p>
engineering, chemical
What problem does this paper attempt to address?