Theoretical and Experimental Study on Hot-Embossing of Glass-Microprism Array without Online Cooling Process

Manfeng Hu,Jin Xie,Wei Li,Yuanhang Niu

DOI: https://doi.org/10.3390/mi11110984

IF: 3.4

2020-10-31

Micromachines

Abstract:Optical glass-microprism arrays are generally embossed at high temperatures, so an online cooling process is needed to remove thermal stress, but this make the cycle long and its equipment expensive. Therefore, the hot-embossing of a glass-microprism array at a low strain rate with reasonable embossing parameters was studied, aiming at reducing thermal stress and realizing its rapid microforming without online cooling process. First, the flow-field, strain-rate, and deformation behavior of glass microforming were simulated. Then, the low-cost microforming control device was designed, and the silicon carbide (SiC) die-core microgroove array was microground by the grinding-wheel microtip. Lastly, the effect of the process parameters on forming rate was studied. Results showed that the appropriate embossing parameters led to a low strain rate; then, the trapezoidal glass-microprism array could be formed without an online cooling process. The standard deviation of the theoretical and experimental forming rates was only 7%, and forming rate increased with increasing embossing temperature, embossing force, and holding duration, but cracks and adhesion occurred at a high embossing temperature and embossing force. The highest experimental forming rate reached 66.56% with embossing temperature of 630 °C, embossing force of 0.335 N, and holding duration of 12 min.

chemistry, analytical,nanoscience & nanotechnology,instruments & instrumentation,physics, applied

What problem does this paper attempt to address?

The main problem that this paper attempts to solve is to achieve low - cost and rapid micromolding of optical glass micro - prism arrays through the low - strain - rate hot - embossing method without using the in - line cooling process. Specifically, the research aims to reduce thermal stress and achieve this goal through reasonable hot - embossing parameters. This can significantly shorten the processing cycle, reduce equipment costs, and avoid the complexity and high - cost problems brought by in - line cooling.

The paper mentions that the traditional hot - embossing process requires in - line cooling to remove thermal stress, resulting in a long processing cycle and expensive equipment. Therefore, this paper proposes a method of hot - embossing at a lower strain rate. By optimizing parameters such as embossing temperature, embossing force and holding time, rapid molding of glass micro - prism arrays without in - line cooling is achieved. The experimental results show that appropriate hot - embossing parameters can achieve a low - strain - rate, thus successfully preparing trapezoidal glass micro - prism arrays without using in - line cooling.