Abstract:Due to their amorphous structure, metallic glasses exhibit remarkable properties such as high strength, hardness, and elastic strain limit. Conversely, they also exhibit high susceptibility to brittle fracture, making them less qualified for the use as monolithic structural components. Therefore, they may be preferably used as the reinforcing phase in hybrid materials combined with ductile matrix materials. Especially metal matrix composites with interpenetrating structures are suitable. This requires an open-porous structure of the metallic glass. In the study at hand, an open-porous lattice structure was manufactured from metallic glass powder (Ni60Nb20Ta20) by laser powder bed fusion. A parameter study was carried out with various scanning strategies to manufacture a mechanically stable lattice structure while maintaining the amorphous structure of the metallic glass. Thus, X-ray diffraction measurements were conducted to validate the parameter study. A stable lattice structure with a largely amorphous structure was successfully achieved with a scanning strategy of single scanned lines and a rotation of 90° for each layer. However, nanocrystallization of 7% occurred in the heat-affected zones formed between the individual printed layers during reheating. Conducting compression tests, a compressive modulus of 18 GPa and a maximum strength of 90 MPa in 0°-direction were achieved. In 90°-direction, no compressive modulus could be determined but compressive strength resulted in 15 MPa. Performing nanoindentation with a Young's modulus of 195.1 GPa and Vickers hardness of HVIT = 956.1 was achieved for the printed bulk metallic glass alloy. The resulting lattice structure was further characterized by differential scanning calorimetry for thermal behavior.

Controlling the Glassy State toward Structural and Mechanical Enhancement: Additive Manufacturing of Bulk Metallic Glass Using Advanced Laser Beam Shaping Technology (Adv. Funct. Mater. 12/2024)

Microstructural control in metal laser powder bed fusion additive manufacturing using laser beam shaping strategy

Laser additive manufacturing of metallic glasses: issues in vitrification and mechanical properties

Additive manufacturing of alloys with programmable microstructure and properties

Controllable additive manufacturing of gradient bulk metallic glass composite with high strength and tensile ductility

Additive Manufactured Large Zr-Based Bulk Metallic Glass Composites with Desired Deformation Ability and Corrosion Resistance

Laser-Based Additive Manufacturing and Characterization of an Open-Porous Ni-Based Metallic Glass Lattice Structure (Ni60Nb20Ta20)

Enhancement of plasticity and toughness of 3D printed binary Zr50Cu50 bulk metallic glass composite by deformation-induced martensitic transformation

The interplay of local chemistry and plasticity in controlling microstructure formation during laser powder bed fusion of metals

Development and Fabrication of Biocompatible Ti-Based Bulk Metallic Glass Matrix Composites for Additive Manufacturing

Material-structure-performance integrated laser-metal additive manufacturing

Research Progress and Current Situation of Laser Additive Technology

Shaping metallic glasses by electromagnetic pulsing

Influence of powder characteristics on the structural and the mechanical properties of additively manufactured Zr-based bulk metallic glass

Dynamic multi-focus laser sculpting of freeform 3D glass microstructures

Mechanical Properties of Bulk Metallic Glasses Additively Manufactured by Laser Powder Bed Fusion: A Review

Structural investigations of Fe-Zr-Si-Cu metallic glass with low glass-forming ability produced in laser powder bed fusion technology

Numerical investigation of laser powder bed fusion of glass

High-Throughput Synthesis and Characterization Screening of Mg-Cu-Y Metallic Glass

Selective laser melting of glass with irregular shaped powder

3D morphological analysis of Fe-based metallic glass surfaces via laser powder bed fusion using a digital microscope