Abstract:When unbalanced insulation is applied to double circuit transmission lines on the same tower,the minimum degree of insulation unbalancedness,by which the lower insulation level is configured at one of the double circuit transmission lines to ensure that the phase-to-phase flashover always occurs at the side with the lower insulation level,is analyzed by electromagnetic transient program(EMTP),and a corresponding insulation configuration scheme is provided.When the balanced insulation or the insulation with low unbalancedness is adopted to double circuit transmission lines on the same tower,the inter-circuit flashover caused by lightning stroke usually happens,namely there is a single-phase flashover in each circuit,however along with the extension of the difference in insulation levels for the two circuits,the inter-circuit flashover gradually turns to phase-to-phase flashover happening at the circuit with the lower insulation level.Based on this principle and by means of ensuring enough difference between insulation levels for the two circuits,it can make sure that when double circuit transmission lines on the same tower is lightning-stricken the phase-to-phase flashover only happens at the circuit with the lower insulation level,therefore the serious fault of simultaneous trip-out of two circuits can be avoided at the cost of trip-out of one circuit.Calculation results show that when the degree of insulation unbalancedness for double 220 kV or 110 kV circuit transmission lines on the same tower reaches to 30%,or in other word,the difference in insulator pieces of a string between two 220 kV circuits or two 110 kV circuits is 4 or 3 pieces respectively,the unbalanced insulation can restrict the circuit,where phase-to-phase flashover happens.Besides,the effect of such a measure is reliable and suitable for double circuit transmission lines on the same tower with various conductor arrangements of phase sequence to avoid simultaneous trip-out of both circuits for double circuit transmission lines on the same tower due to lightning stroke.

Analysis of Insulation Breakdown of Two Sides Breaker in 220 kV Transmission Line Caused by Multiple Lightning Strikes

Experimental Study of Protection Measures for Preventing 10 KV Insulated Conductors from Breakage Caused by Lightning Stroke

Research on Lightning Protection of 220kv Substation with Long Cable Inlet Wire

Development of Surge Arresters With Series Gap Against Lightning Breakage of Covered Conductors on Distribution Lines

220Kv Transmission Line Fault Diagnosis and Analysis

Research on lightning intruding waves in 220 kV GIS substation

Approaching to Rotated Lightning Strike on Transmission Line

Research on lighting fault identification technology of transmission lines based on non-contact sensing

Research of the Lightning Protection Performance for 220 Kv Double-Circuit Transmission Line

Analysis and research on breakdown cause of lightning arrester at low voltage side of 220kV transformer

On the 110kV High Voltage Transmission Line Lightning Protection

Study on Lightning Protection Hardware Against Lightning-Caused Breaking of Insulation-Covered Conductors in 10 Kv Overhead Distribution Networks

Simulation on lightning overvoltage of ±800kV converter station

Simulated Calculation and Analysis of Lightning Performance of UHV A.C. Transmission Line

Analysis of the Lightning Strike Fault of 110 Kv Jianqian Transmission Line in Guizhou and Lightning Protection Measures

Precise Lightning Strike Detection in Overhead Lines Using KL-VMD and PE-SGMD Innovations

Induced voltage at two poles of 10kV parallel distribution line caused by direct lightning strike on the phase wire of adjacent line

Application of Unbalanced Insulation in 220 Kv and 110 Kv Double-Circuit Transmission Lines on the Same Tower

Lightning Performance of the Dinghai- Ningbo East Extra-large Span Transmission Line

Analysing on Characteristics of Lightning Shielding Failure of UHVAC Double Circuit Transmission Line Based on Leader Progression Method

Discussion on Measures Against Lightning Breakage of Covered Conductors on Distribution Lines