Abstract:Lithium–sulfur (Li–S) batteries are severely hindered by the low sulfur utilization and short cycling life, especially at high rates. One of the effective solutions to address these problems is to improve the sulfiphilicity of lithium polysulfides (LiPSs) and the lithiophilicity of the lithium anode. However, it is a great challenge to simultaneously optimize both aspects. Herein, by incorporating the merits of strong absorbability and high conductivity of SnS with good catalytic capability of ZnS, a ZnS-SnS heterojunction coated with a polydopamine-derived N-doped carbon shell (denoted as ) with uniform cubic morphology was obtained and compared with the ZnS-SnS2@NC heterostructure and its single-component counterparts ( and SnS2@NC). Theoretical calculations, ex situ XANES, and in situ Raman spectrum were utilized to elucidate rapid anchoring-diffusion-transformation of LiPSs, inhibition of the shuttling effect, and improvement of the sulfur electrochemistry of bimetal ZnS-SnS heterostructure at the molecular level. When applied as a modification layer coated on the separator, the cell with optimized lithiophilicity and sulfiphilicity enables desirable sulfur electrochemistry, including high reversibility of 1149 mAh g–1 for 300 cycles at 0.2 C, high rate performance of 661 mAh g–1 at 10 C, and long cycle life with a low fading rate of 0.0126% each cycle after 2000 cycles at 4 C. Furthermore, a favorable areal capacity of 8.27 mAh cm–2 is maintained under high sulfur mass loading of 10.3 mg cm–2. This work furnishes a feasible scheme to the rational design of bimetal sulfides heterostructures and boosts the development of other electrochemical applications.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsnano.1c00270?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsnano.1c00270</a>.Additional experimental sections (materials synthesis, characterizations, and DFT calculations); SEM, TEM, XRD, TG, XPS, BET, and XANES characterizations of the samples; CV curves; discharge–charge profiles and cycle performance of various electrodes; in situ Raman tests; optimized geometries of LiPSs; Tables S1–S6: Li+ diffusion rates, EIS fitting, and comparisons of electrochemical performance (<a class="ext-link" href="/doi/suppl/10.1021/acsnano.1c00270/suppl_file/nn1c00270_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Simultaneous acceleration of sulfur reduction and oxidation on bifunctional electrocatalytic electrodes for quasi-solid-state Zn–S batteries

Bidirectional Atomic Iron Catalysis of Sulfur Redox Conversion in High‐Energy Flexible ZnS Battery

Confined tandem catalytic quasi-solid sulfur reversible conversion for all-solid-state Na–S batteries

Synergistic Electrocatalysis and Spatial Nanoconfinement to Accelerate Sulfur Conversion Kinetics in Aqueous Zn−S Battery

Quasi‐Solid Sulfur Conversion for Energetic All‐Solid‐State Na‐S Battery

Reconstructing phase of vanadium oxides enables redox-catalysis manipulated reversible sulfur conversion for stable Zn-S batteries

Sulfurized Composite Interphase Enables a Highly Reversible Zn Anode

Facilitating the Electrochemical Oxidation of ZnS through Iodide Catalysis for Aqueous Zinc–Sulfur Batteries

Isolated diatomic Zn-Co metal–nitrogen/oxygen sites with synergistic effect on fast catalytic kinetics of sulfur species in Li-S battery

Modulation of Potential-Limiting Steps in Lithium-Sulfur Batteries by Catalyst Synergy

Engineering Catalytic CoSe–ZnSe Heterojunctions Anchored on Graphene Aerogels for Bidirectional Sulfur Conversion Reactions

Double-shelled Zn–Co single-atoms enable enhanced conversion kinetics in lithium–sulfur batteries

Boosting Bi‐Directional Redox of Sulfur with Dual Metal Single Atom Pairs in Carbon Spheres Toward High‐Rate and Long‐Cycling Lithium–Sulfur Battery

Implanting Single Zn Atoms Coupled with Metallic Co Nanoparticles into Porous Carbon Nanosheets Grafted with Carbon Nanotubes for High‐Performance Lithium‐Sulfur Batteries

Initiating a Reversible Aqueous Zn/Sulfur Battery through a “Liquid Film”

ZnS-SnS@NC Heterostructure as Robust Lithiophilicity and Sulfiphilicity Mediator toward High-Rate and Long-Life Lithium–Sulfur Batteries

Bidirectional tandem catalysis coupled with interface engineering and Se vacancies for accelerating the polysulfide conversion

Hybrid Electrolyte Design for High‐Performance Zinc–Sulfur Battery

Synergizing Spatial Confinement and Dual‐Metal Catalysis to Boost Sulfur Kinetics in Lithium–Sulfur Batteries

Expediting Redox Kinetics of Sulfur Species by Atomic‐scale Electrocatalysts in Lithium–sulfur Batteries

Bidirectional Catalysts for Liquid–Solid Redox Conversion in Lithium–Sulfur Batteries