Preparation and performance study of ZnWO4/TiO2/MoS2 ternary composite photocatalyst

Hanbi Zhang,Xiangchun Liu,Zhengguang Li,Fei Wang,Jie Zhang,Feng Gao,Ping Zhang,Ziyao Wei
DOI: https://doi.org/10.1007/s10853-023-08995-2
IF: 4.5
2023-12-20
Journal of Materials Science
Abstract:The ZnWO 4 /TiO 2 /MoS 2 (ZTM) ternary composite catalyst was prepared based on the excellent performance binary photocatalyst semiconductor ZnWO 4 /TiO 2 composite powder. The application potential of the photocatalyst to decolorization of methylene blue (MB) dyes under sunlight was studied. The composites were characterized by X-ray diffraction technique (XRD), transmission electron microscopy (TEM), and X-ray photoelectron spectroscopy (XPS). The properties of the composites were tested with BET methods, ultraviolet–visible (UV–Vis) spectrophotometer and photoluminescence (PL) techniques. The experimental results indicate that the ternary catalyst has a nanorod-like morphology, better crystallinity, and large specific surface area. The specific surface area of ZTM-0.5 semiconductor photocatalyst is 2.54 times that of pure ZnWO 4 and 1.83 times that of binary semiconductor photocatalyst. Compared with pure ZnWO 4 , the band gap of ZnWO 4 is significantly reduced, and it has excellent photocatalytic properties, and the degradation rate of MB can reach 99%. The composite of MoS 2 also inhibits the composite of photogenerated electron–hole pairs, improves the concentration of photocatalytic intermediates, not only improves the photocatalytic activity, but also improves the stability of the photocatalyst. After three cycles of degradation experiments, the degradation efficiency of ZTM-0.5 photocatalyst remains at 65%. The main radical affecting the photocatalysis through the trapping agent benzoquinone test is the superoxide radicals (·O 2 − ).
materials science, multidisciplinary
What problem does this paper attempt to address?