Abstract:High molecular weight polymers are required for the purpose of mobility and conformance control during surfactant chemical flooding. However, they are usually not incorporated in the process of phase behavior tests to screen surfactant formulations. Literature review shows some particular polymers have a boosting effect on surfactant solubilization efficiency. To gain more insight into this subject, we performed phase behavior tests in the presence of four commonly used EOR polymers for low concentration surfactant systems (0.3%). They were two partially hydrolyzed polyacrylamides (HPAM) with different molecular weights, one xanthan gum, and one hydrophobically associating polymer (HAP). Their influence on the optimal salinity, solubilization ratio, quickness of phase equilibration, and middle phase rheological behavior was assessed. The results showed: (1) a decrease of surfactant solubilization efficiency and the optimal salinity was observed with HPAM polymers. This trend became more pronounced as increase of polymer concentration and molecular weight; (2) xanthan seemed to slightly increase the optimal salinity without significantly affecting middle phase volume; (3) both HPAM and xanthan did not delay or quicken the equilibration of various phases compared to the zero polymer case. The analysis of the oil/water solubilization ratios showed HPAM tended to drag water out of the middle phase, while the presence of xanthan increased the water solubilization in the middle phase; (4) the viscosity and rheology of the middle phase microemulsions were very similar for systems containing HPAM, xanthan, and zero polymer. This confirmed the partitioning of polymer molecules in the middle phase was negligible; (5) the association of HAP with surfactants thickened the surfactant-rich phase, which made the phase separation dramatically slow. These phenomena could be explained well by the nature of their molecular structures. For both water-soluble HPAM and xanthan gum, unlike the reported diblock copolymers, they lack the amphiphilic features, which prevents them from adsorbing in the surfactant film. Conversely, the introduction of hydrophobic group into the backbone renders associating polymers some surfactant-like attributes, enabling them to associate with surfactant molecules and affect the surfactant-rich phase behaviors.

The distribution of plasticizers between aqueous and polymer phases in aqueous colloidal polymer dispersions

Phase separation in aqueous stabilizer-free two-phase polymerization

Determination of Plasticizers Commonly Used In Pharmaceutical Dosage Forms by High Performance Liquid Chromatography

Polymer blends used for the aqueous coating of solid dosage forms: importance of the type of plasticizer

Plasticization of cellulose ethers used in the film coating of tablets

Poly(d,l-lactide-co-glycolide) Dispersions Containing Pluronics: from Particle Preparation to Temperature-Triggered Aggregation

Synthesis of plant oil derived polyols and their effects on the properties of prepared ethyl cellulose composite films

Study On The Synthesis And Properties Of Water Soluble Superplasticizer With Side Branch Poly(Ethylene Glycol) Methyl Ether

How to solve the problem of co-elution between two compounds in liquid chromatography through the first UV derivative spectrum. A trial on alternative plasticizers to di(2-ethylhexyl) phthalate

Investigation on Changes in the Miscibility, Morphology, Rheology and Mechanical Behavior of Melt Processed Cellulose Acetate Through Adding Polyethylene Glycol As A Plasticizer

Peculiar effect of polyethylene glycol in comparison with triethyl citrate or diethyl phthalate on properties of ethyl cellulose microcapsules containing propranolol hydrochloride in process of emulsion-solvent evaporation

Cellulose nanocrystals concentration and oil-water ratio for solid-liquid controllable emulsion polymerization

Effect of commonly used EOR polymers on low concentration surfactant phase behaviors

Green Williamson enhancement of the hydrophobic properties of cellulose fibers: thermodynamic study and application to elaborate rosemary essential oil (REO) biodegradable plastic coacervates

Towards natural care products: structural and deposition studies of bio-based polymer and surfactant mixtures

An in vitro method to investigate food effects on drug release from film-coated beads

Plasticized Cellulosic Films by Partial Esterification and Welding in Low-Concentration Ionic Liquid Electrolyte

Facile exfoliation and physicochemical characterization of Thespesia populnea plant leaves based bioplasticizer macromolecules reinforced with polylactic acid biofilms for packaging applications

The Influence of Different Plasticizers and Polymers on the Mechanical and Thermal Properties, Porosity and Drug Permeability of Free Shellac Films

Synthesis and application of eleostearic acid based plasticizer