Abstract:On the basis of the observed experimental behavior of axially loaded friction piles driven in soft clays, a soil-pile interface model is proposed using the basic rheological units: springs, dashpots and sliding elements. All the mass of soil affected by the presence of the pile is concentrated in a ring of infinitesimal width. Therefore, all the phenomena regarding the soil-pile stress distribution and displacements will take place in this surface. The proposed rheological model is introduced in a general boundary elements formulation for axially loaded piles. In this formulation, the pile is discretized in a certain number of elements in order to consider a variety of phenomena such as: the deformation of the pile, the increment of radial and axial stresses in the soil mass due to load transfer and the stiffness of the different layers it passes across. Parameters of the rheological model can be obtained from a creep triaxial test and a direct shear test. In case the pile cuts through different layers, it is necessary to compute the parameters for each layer. The proposed model is able to simulate the load-displacement behavior of axially loaded floating piles subject to monotonic as well as cyclic loading. It is also possible to determine the load and displacement at the pile tip and shear stress distribution along the pile shaft. Results of the proposed model have been compared with a very well documented series of pile tests carried out in Mexico City. Tested piles were squared 30 cm on the side and were driven 10 m in a quite homogeneous clay layer. From these comparisons it can be concluded that the model is able to adequately reproduce the most important aspects of the load-displacement behavior of friction piles driven in clay deposits.

A new pile-soil interface and its application in battered mini piles under monotonic lateral load in cohesive soil

MPM Modeling of Pile Installation in Sand: Contact Improvement and Quantitative Analysis

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Lateral dynamic response of a partially embedded pile subjected to combined loads in saturated soil

Effect of Loading Rate on Lateral Pile-Soil Interaction in Sand Considering Partially Drained Condition

Model Tests on Elevated Piles Subjected to Lateral Static and Impact Loading

New Load Transfer Hyperbolic Model for Pile-Soil Interface and Negative Skin Friction on Single Piles Embedded in Soft Soils

Soil-structure Interface Modeling of Pile-Soil Interaction with an Elasto-Plasticity Damage Model

Soil-Pile Interface Model for Axially Loaded Single Piles

Elastic Solutions for Partially Embedded Single Piles Subjected to Simultaneous Axial and Lateral Loading

A Simplified Nonlinear Calculation Method to Describe the Settlement of Pre-Bored Grouting Planted Nodular Piles

Influence Of Excavation Unloading On Vertical Bearing Behavior Of Existing Pile Groups

A Bounding-Surface-based Cyclic "P-Y Plus M-θ" Model for Unified Description of Laterally Loaded Piles with Different Failure Modes in Clay

An enhanced micromechanical rock–pile interface model with application to rock‐socketed pile modeling

New Interaction Model for the Annular Zone of Stepped Piles with Respect to Their Vertical Dynamic Characteristics

Load Transfer of Offshore Open-Ended Pipe Piles Considering the Effect of Soil Plugging

A Multi-Axial Bounding Surface P-Y Model with Application in Analyzing Pile Responses under Multi-Directional Lateral Cycling

Behavior Analysis of Laterally Loaded Single Pile under Large Deflection

Influence of soil and pile properties on the critical length of laterally loaded piles

Equivalent linear model for the lateral dynamic analysis of pile foundations considering pile-soil interface degradation