Abstract:Due to continuous improvements in the beneficiation process, the size of tailings has decreased. In many mines, more than 50% of the total tailings are finer than 74 μ m. Ultrafine tailings exhibit a slow settling velocity and uneven settling, which pose new challenges to the safety and stability of tailings dams. In this paper, ultrafine iron tailings from the Makeng Iron Mine in Longyan City, Fujian Province, were used as the research object. A four-factor, three-level orthogonal test method was used to study the sedimentation characteristics of ultrafine tailings with four common curing agent materials, including polyacrylamide, polyaluminum chloride, polyaluminum sulfate, and polyferric sulfate. The results show that when the pulp concentration is 30%, the polyacrylamide is cationic and the molecular weight is 10 million, the optimal content of the flocculant is 3‰, the optimum dose of the polyaluminum chloride with a content of 28 is 0.1‰, the optimum dose of polyaluminum sulfate is 1‰, and the optimum dose of polymeric ferric sulfate is 1‰. When the flocculant is mixed according to the proportion of 2‰ polyacrylamide, 0.05‰ polyaluminum chloride, 1‰ polyaluminum sulfate, and 1.0‰ polyferric sulfate, the sedimentation speed of the ultrafine tailings is fast, and the supernatant liquid is clear. The results of multivariate nonlinear regression analysis of the sedimentation curve show that the primary and secondary factors affecting sedimentation are polyacrylamide > polyaluminum sulfate > polyaluminum chloride > polyferric sulfate. When the optimal ratio is applied, the cohesion (c) of ultrafine tailings increases from 27 kPa to 68.75 kPa and the internal friction angle ( φ ) increases from 25.53° to 27.53°, which shows that the shear strength improves and the stability of the tailings dam increases. The economic analysis of the composite flocculant with the optimal ratio shows that the flocculant with the optimal proportion has an obvious economic advantage over polyacrylamide alone.

Effect of solution pH and polyethylene oxide concentration on surface/interface properties, flocculation and rheology of concentrated monodisperse ultrafine synthetic tailings slurry

Effect of Sequentially Adsorbed Multilayers, Citric Acid(ca)-Pei-ca-pei and PEI-CA-PEI-CA, on the Surface Chemistry and Rheology of Spherical Α-Alumina Suspensions

Enhancing solid-liquid separation performance of copper tailings by regulating settling floc properties

Study on the Effect of Flocculation and Sedimentation on the Mechanical Properties of Iron Tailing Sand

Interaction between PEO and Kaolinite in Flocculating: An Experimental and Molecular-Simulation Study

Rheological Behavior of Clay Tailings in the Presence of Divalent Cations and Sodium Polyacrylate: Insights from Molecular Dynamics Simulations

Quantifying the effect of polyacrylamide dosage, Na+ and Ca2+ concentrations, and clay particle size on the flocculation of mature fine tailings with robust statistical methods

Enhanced flocculation and sedimentation of copper tailings by polycarboxylate ether superplasticizer

Analysis of the Sedimentation Characteristics of Ultrafine Tailings Based on an Orthogonal Experiment

Flocculation and dewatering of the Kaolin slurry treated by single- and dual-polymer flocculants

Enhanced Flotation Separation of Iron and Silicon with Branched Block Polyethylene Oxide Polypropylene Oxide and Sodium Oleate: Mechanisms and Flotation Behavior

Effects of a New Synthetic Fe-PAM Flocculants on Filtration and Consolidation of Bentonite Slurry

Influence of pH and salt solution on the sedimentation properties of fine bauxite tailings

Study on the preparation of polysilicate ferric flocculant and its treatment of high turbidity tailings water

Effect of interparticle interactions on the yield stress of thickened flocculated copper mineral tailings slurry

Influence of Two-Stage Dosing on Flocculation and Settlement of Kaolinite and Associated Mechanisms

Effect of Flocculants Residue on Rheological Properties of Ultra-Fine Argillaceous Backfilling Slurry

Effects of agitation intensity and foam stability on the Floc-flotation of ultrafine minerals using a laboratory flotation column

Molecular Relaxation and Rheological Behaviors of Silica/Poly(propylene Oxide)dispersions

Effect of Ph on Ultrafine ZrO_2 Slurry Properties

Polymer Effects on the Equimolar Mixed Cationic–anionic Surfactants