Abstract:Aging study of photovoltaic (PV) modules requires PV curves analysis at the same conditions of irradiance and temperature as standard test conditions (STC). However, in practical cases, PV characteristics are measured at different conditions other than STC. Therefore, translating these curves to one constant condition is a crucial step to accurately estimate the performance of PV modules. The aim of this work is to develop new translation equations to improve the accuracy and simplify the translating of PV performance values from one set of irradiance and temperature conditions to STC fixed conditions. It should be noted that various translation approaches are published in the literature, all varying in the degree of mathematical complexity or accuracy of translation from low irradiance levels. The translation equations presented in this work are intended to provide researchers with a simple and accurate method of PV performance translation. The introduction of dimensionless temperature and irradiance coefficients further simplifies the approach because these coefficients are the same (or nearly so) for a cell and PV module. A comparative study of four approaches is also performed to translate the PV performance of three PV module technologies, when they are exposed to the same real conditions over a one-year period under the meteorological conditions of Cocoa city (subtropical-climate)/Florida. Modules of monocrystalline silicon (xSi12922), multicrystalline silicon (mSi0166) and amorphous silicon (HIT05667) technologies were studied. PV module' data were provided by the National Renewable Energy Laboratory (NREL), USA. These modules were characterized by their experimental current-voltage I(V) curves according to the average back temperature of the module and the daily irradiation. The obtained results show that the proposed method outperforms the all other three translation methods and shows promising results. Indeed, it records the lowest and constant RMSE value, whatever the weather conditions in the day, and high efficiency in accurately translating PV curves to fixed STC even from low irradiation level. The average RMSEs' range for one day is under 0.4 for all analyzed PV module technologies. Therefore, the suggested translation method is proven to be a promising and efficient tool for future studies such aging and defaults diagnosis.

A robust I–V curve correction procedure for degraded photovoltaic modules

Identifying PV Module Mismatch Faults by a Thermography-Based Temperature Distribution Analysis

A Robust Parametrization Method of Photovoltaic Modules for Enhancing One-Diode Model Accuracy under Varying Operating Conditions

Comparative of IEC 60891 and Other Procedures for Temperature and Irradiance Corrections to Measured I–V Characteristics of Photovoltaic Devices

In-Situ Measurement of Power Loss for Crystalline Silicon Modules Undergoing Thermal Cycling and Mechanical Loading Stress Testing

A series resistance extraction method for health evaluation of photovoltaic modules

Defect Detection and Degradation Analysis in Photovoltaic Modules Using Thermography, Spectroscopy, and Current–Voltage Measurements, and Quantitative Assessment of Their Impact

In-Situ Self-Monitoring of Real-Time Photovoltaic Degradation Only Using Maximum Power Point: the Suns-Vmp Method

Performance Assessment of Mismatch Mitigation Methodologies Using Field Data in Solar Photovoltaic Systems

A Simple Mismatch Mitigating Partial Power Processing Converter for Solar PV Modules

Photovoltaic Modeling: A Comprehensive Analysis of the I–V Characteristic Curve

A Multi-State Dynamic Thermal Model for Accurate Photovoltaic Cell Temperature Estimation

A Fast MPPT-based Anomaly Detection and Accurate Fault Diagnosis Technique for PV Arrays

Design of a Portable Low-Cost I-V Curve Tracer for On-Line and In Situ Inspection of PV Modules

Dynamic Performance Enhancement in 2D and 3D Curved Flexible Photovoltaic Modules: Mismatch Loss Analysis and Cell Interconnection Configurations Optimization

Fast simulation modeling and multiple-PS fault diagnosis of the PV array based on I–V curve conversion

Low-Cost I–V Tracer for PV Fault Diagnosis Using Single-Diode Model Parameters and I–V Curve Characteristics

A fault diagnosis method for photovoltaic module current mismatch based on numerical analysis and statistics

New translation method to STC of photovoltaic module characteristics: A comparison of conventional approaches and proposal of a novel method

A Novel Data-driven State Evaluation Approach for Photovoltaic Arrays in Uncertain Shading Scenarios

An Novel Explicit Model for Photovoltaic I-V Characteristic Prediction Based on Different Splitting Spectrum