Abstract:In this work, the SnO 2 -Ti 3 C 2 hybrid electron transport layer (ETL) was prepared by incorporating two-dimensional Ti 3 C 2 -MXene into SnO 2 and appropriate ultraviolet (UV) ozone treatment. The synergistic effect of Ti 3 C 2 introduction and UV ozone treatment on the charge transport capacity of SnO 2 ETL, interface properties of ETL/perovskite, perovskite morphology, and device performance was systematically investigated. The results show that the introduction of Ti 3 C 2 does not affect the morphology and transmittance of SnO 2 ETL. The perovskite films based on SnO 2 -Ti 3 C 2 are not only dense, but also have smaller surface roughness, more uniform, and larger grain size, even penetrating the entire perovskite film. The surface oxidation of Ti 3 C 2 induced by UV-ozone treatment enhanced the charge transport capacity of ETL. The electron extraction and charge transfer at the interface between SnO 2 -Ti 3 C 2 ETL and perovskite are higher, and carrier recombination is effectively suppressed. Perovskite solar cells (PSCs) based on SnO 2 -Ti 3 C 2 ETL have larger charge recombination impedance and higher electron mobility, mainly due to enhanced ETL charge transport and optimization of interface properties. The short-circuit current ( J sc) and filling factor (FF) of PSCs are increased by 5% and 7% respectively, delivering a champion device with a relatively high FF of 79.38% and high power conversion efficiency of 19.52%, as well as good stability. Thus, this study provides a simple and effective method for the preparation of efficient and repeatable PSCs and paves the way for the industrialization of PSCs to a certain extent.

cPCN-Regulated SnO2 Composites Enables Perovskite Solar Cell with Efficiency Beyond 23%

Enhancing Electron Extraction and Transport in Inorganic Perovskite Solar Cells Via Additional Built-in Potential of SnO2-BiFeO3 Nano-Heterostructure

Fullerene Derivative-Modified SnO2 Electron Transport Layer for Highly Efficient Perovskite Solar Cells with Efficiency over 21

Efficient Perovskite Solar Cells Based on Polyoxyethylene Bis(amine) and NaPF6 Modified SnO2 Layer with High Open-Circuit Voltage

SnO2-Carbon Nanotubes Hybrid Electron Transport Layer for Efficient and Hysteresis-Free Planar Perovskite Solar Cells

Superior SnO2 Electron Transport Layer Via Bifunctional Interfacial Regulation Using Cesium Sulfate for Efficient Perovskite Solar Cell

Multi-cation hybrid stannic oxide electron transport layer for high-efficiency perovskite solar cells

TiO2/SnO2 Nanocomposites As Electron Transporting Layer for Efficiency Enhancement in Planar CH3NH3PbI3-Based Perovskite Solar Cells

SnO2-Ti3C2 Blends As Electron Transport Layer for Efficient and Easily Fabricated Planar Perovskite Solar Cells

Enhanced Charge Transport and Interface Passivation in Efficient Perovskite Solar Cells Using Sulfur‐Doped Graphite Carbon Nitride‐Modified SnO2‐Based Electron Transport Layers

Multifunctional Polymer‐Regulated SnO 2 Nanocrystals Enhance Interface Contact for Efficient and Stable Planar Perovskite Solar Cells

Gradient Energy Alignment Engineering for Planar Perovskite Solar Cells with Efficiency Over 23.

Polyelectrolyte-Doped SnO<sub>2</sub> as a Tunable Electron Transport Layer for High-Efficiency and Stable Perovskite Solar Cells

Red‐Carbon‐Quantum‐Dot‐Doped SnO2 Composite with Enhanced Electron Mobility for Efficient and Stable Perovskite Solar Cells

Multifunctional Compound‐Regulated SnO2 for High‐Efficiency and Stable Perovskite Solar Cells under Ambient Air

Enhanced Efficiency and Stability of Planar Perovskite Solar Cells Using SnO2:InCl3 Electron Transport Layer Through Synergetic Doping and Passivation Approaches

Enhanced Charge Transport and Interface Passivation in Efficient Perovskite Solar Cells Using Sulfur‐Doped Graphite Carbon Nitride‐Modified SnO 2 ‐Based Electron Transport Layers

Iodine-doped g-C3N4 modified zinc titanate electron transporting layer for highly efficient perovskite solar cells

Suppressing Charge Recombination in Planar Perovskite Solar Cells by Using SnO2/TiO2 Nanocomposite As Electron Transfer Layer

NaCl-passivated and Na+-doped Tin Oxide Electron Transport Layers Enable Highly Efficient Planar Perovskite Solar Cells

Enhanced Performance of Carbon-Based Perovskite Solar Cells with a Li+-doped SnO2 Electron Transport Layer and Al2O3 Scaffold Layer