Combustibility and Cofiring of Coal Gasification Fine Ash with High Carbon Content in a Full-scale Pulverized Coal Furnace

Xing Liu,Xuebin Wang,Hu Sheng,Jiaye Zhang,Chaoqiang Yang,Zia ur Rahman,Lan Zhang,Houzhang Tan

DOI: https://doi.org/10.1021/acs.energyfuels.0c02171

2020-09-18

Abstract:Coal gasification fine ash (CGFA) having a high carbon content is produced in large quantity as a byproduct from coal gasifiers in China. CGFA is usually disposed of by landfill as a solid waste, which is not only detrimental to environment but also a loss of an enormous energy that renders the process inefficient. Therefore, it is crucial to make use of the high carbon content in the CGFA with an economic and environmentally friendly method. In this study, the ignition and burnout behavior of CGFA were investigated via a thermogravimetric analyzer (TGA), flat-flame burner (FFB), and drop-tube furnace (DTF). Further, the cofiring of CGFA was numerically studied in a tangentially fired pulverized coal boiler burning anthracite with various cofiring ratios (0%, 10%, 20%, and 30%). The TGA results show the similar oxidation reactivity, oxidation kinetics, and ignition behavior of CGFA with the anthracite. In the FFB atmosphere with practical heating rates, the CGFA and anthracite are both heterogeneously ignited with an ignition time of 8.1 and 7.6 ms, respectively. The particle size significantly affected the ignition time of CGFA, as the particle size decreased from 125 to 135 μm to 45–63 μm and the ignition time of CGFA decreased from 10.1 to 5.6 ms. The burnout test in DTF indicates that the promising burnout performance in a pulverized coal furnace required a crucial oxygen concentration >10%, and the CFD simulation results coincided well with the experimental data from DTF. The CFD modeling results of the full-scale furnace show that the cofiring of CGFA is feasible in the pulverized coal furnace burning anthracite. Compared with the mode of pure anthracite combustion, under the cofiring mode with 10–30% CGFA as the energy input, the central maximum temperature of the main combustion zone increases by 50–90 °C, resulting in the slightly improved burnout for both anthracite and CGFA.This article has not yet been cited by other publications.

energy & fuels,engineering, chemical

What problem does this paper attempt to address?

The problem this paper attempts to address is the combustion characteristics and co-firing feasibility of high-carbon content coal gasification fine ash (CGFA) in coal-fired furnaces. CGFA, as a by-product of the coal gasification process, has a large annual production in China. Currently, it is mainly disposed of through landfilling, which not only harms the environment but also wastes a significant amount of energy. Therefore, it is crucial to study its combustion characteristics and how to co-fire it in coal-fired furnaces to achieve economic and environmental benefits. The paper investigates the ignition and burnout behavior of CGFA through thermogravimetric analysis, flat flame burner experiments, and drop tube furnace experiments. Additionally, it evaluates the co-firing potential of CGFA with anthracite using computational fluid dynamics (CFD) simulations. The results indicate that CGFA can be successfully co-fired in coal-fired furnaces and can increase the temperature in the main combustion zone, thereby improving combustion efficiency.

Combustibility and Cofiring of Coal Gasification Fine Ash with High Carbon Content in a Full-scale Pulverized Coal Furnace

Combustibility analysis of high-carbon fine slags from an entrained flow gasifier

Effect of Chemical Compositions on Ash Fusibility Characterization of a Jincheng Anthracite During Combustion and Gasification

Decarburization and ash characteristics during melting combustion of fine ash from entrained-flow gasifier

Resource utilization of gasified fine ash from entrained flow bed via thermal modification-melting combustion: A pilot study

A pilot scale test on the fluidized melting combustion of coal gasification fine slag

Study of Combustion Characteristics and Matching Between the Blends of Gasification Fine Slag and Coal with Varied Ranks

Process design and thermal-calculation of a novel entrained-flow gasifier using fine ash as feedstock

Experimental study on thermal modification characteristics of entrained-flow gasified fine ash using circulating fluidized bed

Investigation of the Characteristics of Catalysis Synergy During Co-Combustion for Coal Gasification Fine Slag with Bituminous Coal and Bamboo Residue

Efficient decarburization modification of coal gasification fine ash by microwave field activation

Modification of Melting Combustion Kinetic Model of Fine Ash from Entrained-Flow Gasifier

Characterization of fly ash and unburned carbon from CFB boiler with burning Fujian anthracite

Study on physicochemical properties, distribution modes, and formation mechanism of coal gasification fine slag in an industrial entrained-flow gasifier

Evaluation of cofiring bioferment residue with coal at different proportions: Combustion characteristics and kinetics

Utilization of Coal gasification fine ash for construction material: From physical and chemical properties to the hydration activity of thermally modified CGFA

Investigation on co-combustion of coal gasification fine slag residual carbon and sawdust char blends: Physiochemical properties, combustion characteristic and kinetic behavior

Study on the feasibility and co-combustion mechanism of mixed injection of biomass hydrochar and anthracite in blast furnace

Assessment on combustion performance and bottom ash properties of carbon‐rich fraction from coal gasification fine slag co‐combustion with corn straw char

Experimental Study and Design of Biomass Co-Firing in a Full-Scale Coal-Fired Furnace with Storage Pulverizing System

Co-combustion kinetic analysis of biomass hydrochar and anthracite in blast furnace injection