Abstract:Given that many mines around the world are located in areas where fresh water is scarce, and companies are being held to increasingly stringent sustainability and environmental responsibility standards, many mines are looking to use locally available saline groundwater or seawater as mixing water in cemented paste backfill (CPB). However, the impacts of this decision on key engineering properties of CPB (e.g. strength and self-desiccation) that affect its mechanical stability need to be better understood to allow confident selection of this practical and more sustainable solution. Thus, the effect of mixing water salinity and binder type on the strength (unconfined compressive strength, UCS) development and self-desiccation (measured by suction and volumetric water content) of CPB is explored in this research. NaCl concentrations from 0 to 300 g/L were used in CPB made with silica tailings and Portland cement type I (PC). Concentrations of 10 and 35 g/L were found to moderately increase UCS, while a concentration of 100 g/L had comparable UCS to non-saline CPB and a concentration of 300 g/L was found to significantly decrease UCS over all curing times. The overall trend is 10 g/L > 35 g/L > 0 g/L > 100 g/L > 300 g/L. The UCS of the 60-day-old CPB with a NaCl of 300 g/L is significantly lower, registering a 26% decrease compared to the UCS of the 60-day-old CPB without salt. In contrast, the UCS of the 60-day-old CPBs containing 10 g/L and 35 g/L of salt exhibits a notable improvement, being 15% and 10% higher, respectively, than the UCS of the 60-day-old CPB without salt. Water content and suction monitoring were conducted up to 28 days of curing time, and it was found that suction only slightly contributed to UCS gain of the saline CPB, and high salt contents (100 and 300 g/L) significantly inhibited the self-desiccation ability of CPB due to inhibition of cement hydration by the excessive amount of salt. The increase in strength of both saline and non-saline samples was attributed primarily to the increase in cement hydration products, while the increased strength of the samples with salinities of 10 and 35 g/L was mainly attributed to the enhancement of the binder hydration due to the low amount of salt and the presence of Friedel’s salt in the pores. The effect of PC replacement by 25 to 75% with slag on CPB with 35 g/L mixing water salinity was also studied. Slag replacement of 50% and higher resulted in significantly higher UCS over most curing times. Suction likely moderately contributed to UCS of the saline CPB with slag, in addition to the presence of Friedel’s salt in the pores and the acceleration of cement and slag hydration by the presence of NaCl.

Effects of Seawater, NaCl, and [math] Solution Mixing on Hydration Process of Cement Paste

Rheological properties, compressive strength, hydration products and microstructure of seawater-mixed cement pastes

Effects of Cyclic Seawater Exposure on the Mechanical Performance and Chloride Penetration of Calcium Sulfoaluminate Concrete

Effect of Seawater on Hydration and Sulfate Resistance of Noncement Mortars

Effects of w/b ratio, fly ash, limestone calcined clay, seawater and sea-sand on workability, mechanical properties, drying shrinkage behavior and micro-structural characteristics of concrete

Study on the Binding Behavior of Chloride Ion and Ettringite in Nano-Metakaolin Cement by Seawater Mixing and Curing Temperatures

Hydration of Portland cement with seawater toward concrete sustainability: Phase evolution and thermodynamic modelling

Effects of chloride content on early hydration performance of cement pastes

The Effect of Mixing and Curing Sea Water on Concrete Strength at Different Ages

Effect of super water absorbing polymer based anti-washout admixtures on the properties of seawater-mixed cement paste

Effect of Phaeodactylum Tricornutum in Seawater on the Hydration of Blended Cement Pastes

Effect of Chlorine Salt Content on the Microstructural Development of C-S-H Gels and Ca(OH)2 at Different Curing Temperatures

Investigating the effects of seawater and sea sand aggregates and supplementary cementitious materials on the early shrinkage and crack resistance of concrete

Degradation characteristics of Portland cement mortar incorporating supplementary cementitious materials under multi-ions attacks and drying-wetting cycles

Early crack resistance and life cycle assessment of seawater-mixed sintered sludge cement paste

Development of sustainable concrete incorporating seawater: A critical review on cement hydration, microstructure and mechanical strength

Strength development and self-desiccation of saline cemented paste backfill

Study of the influence of seawater and sea sand on the mechanical and microstructural properties of concrete

Strength Development of Seawater Mixed and Cured Concrete with Various Replacement Ratios of Fly Ash

Development of admixtures on seawater sea sand concrete: A critical review on Concrete hardening, chloride ion penetration and steel corrosion

The Dispersing Performances of Polycarboxylate Superplasticizer in Cement Pastes Prepared with Deionized Water and Seawater