Abstract:Supported by the controlling of crush‐sinter conditions, the homogeneous hereto LCO‐cathodes can be prepared, concentrated particle sizes, uniform distribution of doped elements, and stable crystal structure can be obtained. Interestingly, through tailoring introduction of Li/Co anti‐sites, the regenerated LiCoO2 delivered a considerable capacity retention of 88.86% after 500 cycles at 5.0 C, bringing about fascinated electrochemical performance and structural stability. Captured by relatively low energy consumption and harmful gas‐emission, direct regeneration has captured numerous attention, but still suffers from different particle sizes and diverse doping hetero‐elements, hardly meeting the market demand. Herein, assisted by the crush‐sinter regeneration from element to grain further to particle, homogenized recovery of hetero spent LiCoO2 is successfully carried out. More interestingly, after tailoring Li/Co anti‐sites ratio, the redox activity of Co‐ions is remarkably enhanced, effectively inhibiting the irreversible escape of O‐atoms under high voltage, bringing about the fascinating electrochemical performance and structural stability. As anticipated, the regenerated LiCoO2 delivered a considerable capacity of 175.2 mAh g−1 at 1.0 C, whilst its capacity retention can remain at 88.86% even after 500 cycles at 5.0 C, better than that of commercial materials. Assembling regenerated materials versus. graphite pouch cell, their considerable practical capacity retention can be kept at ≈91.4% even after 500 cycles. Supported by in situ XRD, electronic structure analysis, and detailed DFT calculations, the excellent high voltage stability of optimized samples mainly comes from the alleviating of phase conversion and oxygen redox. This work is expected to shed light on the potential value of homogenized regenerations, and offer effective strategies of upcycling about spent LCO.

Directly-Regenerated LiCoO 2 with a Superb Cycling Stability at 4.6 V

Recycling Spent LiCoO2 for Improved 4.6 V Performance

Sustainable Recovery of LiCoO2 from Spent Lithium-Ion Batteries: Simplicity, Scalability, and Superior Electrochemical Performance

Homogenization and Upcycling of Hetero Spent LiCoO2 Cathodes: Rational Introduction of Li/Co Anti‐Sites Toward Enhanced High‐Voltage Stability

Sustainable regeneration of high-performance LiCoO2 from completely failed lithium-ion batteries

Scalable Precise Nanofilm Coating and Gradient Al Doping Enable Stable Battery Cycling of LiCoO2 at 4.7 V

Revealing Lithium Configuration in Aged Layered Oxides for Effective Regeneration

In Situ Constructed Spinel Layer Stabilized Upcycled LiCoO2 for High Performance Lithium‐Ion Batteries

Sustainable regenerating of high-voltage performance LiCoO2 from spent lithium-ion batteries by interface engineering

Directly Regenerating of Spent LiCoO2 with Gradient F‐doped Subsurface towards Ultra‐stable Storage Properties

Direct recovery of LiCoO2 from the recycled lithium-ion batteries via structure restoration

Multi-scale stabilization of high-voltage LiCoO2 enabled by nanoscale solid electrolyte coating

Collaborative Regeneration of Structural Evolution for High-Performance of LiCoO 2 Materials from Spent Lithium-Ion Batteries

Regenerated Ni-Doped LiCoO 2 from Spent Lithium-Ion Batteries as a Stable Cathode at 4.5 V

Rapid, Direct Regeneration of Spent LiCoO2 Cathodes for Li-Ion Batteries

Tuning surface chemistry to reduce the step-like degradation of LiCoO<sub>2</sub> at 4.6 V

Tuning Surface Chemistry to Reduce the Step-Like Degradation of LiCoO2 at 4.6 V

Multi-scale stabilization of high-voltage LiCoO<sub>2</sub> enabled by nanoscale solid electrolyte coating

Stabilizing LiCoO<sub>2</sub> at 4.6 V by regulating anti-oxidative solvents

Layered over-lithiated oxide coating for reviving spent LiCoO2 cathode for stable high-voltage lithium-ion battery

Direct Regeneration of Spent LiCoO2 Black Mass Based on Fluorenone‐Mediated Lithium Supplementation and Energy‐Saving Structural Restoration