Abstract:The physical and mechanical properties of an entirely (wrought alloys) or partly (cast alloys) dendritically solidified alloy strongly depend on the secondary dendrite arm spacing (SDAS). The casting practice and the simulation of solidification need a usable but simple method to calculate the SDAS during and at the end of solidification as a function of the cooling rate. Based on many solidification experiments, a simple equation to calculate the SDAS (empirical method) is known to use the local solidification time, which can be obtained from the measured cooling curves (equiaxed solidification), or can be calculated from the temperature gradient and front velocity (directional solidification). This equation is not usable for calculating the SDAS during solidification. Kirkwood developed a semi-empirical method based on the liquid phase's diffusion, which contains only one geometric factor that seems constant for different alloys. This equation contains some physical parameters that depend on the temperature, so the equation cannot be integral in closed form. In the present work, first, we show the effect of the curvature of the solid/liquid interface on the equilibrium concentrations and then the different processes of SDA coarsening. In our earlier paper, we demonstrated that using the empirical method, the final SDAS can be calculated with acceptable correctness in the case of four unidirectional solidification experiments of Al-7wt%Si alloy. The present work shows that numerically integrated Kirkwood's equations used the known cooling curve; the SDAS can be calculated at the end and during solidification in good agreement with these experimental results. Compared to the two calculation methods, we stated that the correctness of the methods is similar. Still, the results of the solidification simulation (the microsegregation) will be more correct using the dynamical method. It is also shown that with the dynamical method, the SDAS can be calculated from any type of cooling curve, and using the dynamical method, it is proved that some different SDASs could belong to the same local solidification time.

Applying the Spacing Transform on Secondary Dendrite Arm Spacing Measurements of a Cast High-Strength Low-Alloy Steel

A Numerical Time Integration Procedure for Secondary Dendrite Arm Spacing in Hyper-Peritectic Steel Alloys

Prediction of the Secondary Arms Spacing Based on Dendrite Tip Kinetics and Cooling Rate

Dendritic segregation and arm spacing in directionally solidified CMSX-4 superalloy

Simulation and Experimental Validation of Secondary Dendrite Arm Spacing for AlSi7Mg0.3 Chassis Parts in Low Pressure Die Casting

Characterizing the local primary dendrite arm spacing in directionally-solidified dendritic microstructures

Comparison of Dynamical and Empirical Simulation Methods of Secondary Dendrite Arm Coarsening

Strain partitioning characterization of advanced high strength steels using in-situ tensile tests with Micro digital image correlation – Methodology and analysis

Effects of Alloying Elements on Solidification Structures and Macrosegregation in Slabs

Multiscale prediction of microstructure length scales in metallic alloy casting

Advanced microstructural characterization in high-strength steels via machine learning-enhanced high-speed nanoindentation and EBSD mapping

Effect of secondary orientation on the microstructures in thin-walled castings of nickel-based single-crystal superalloys

Phase Field Study of Spacing Evolution During Wire and Laser Additive Manufacturing under Transient Conditions

Effect of cooling rates on dendrite spacings of directionally solidified DZ125 alloy under high thermal gradient

Mesoscale Deformation Incompatibility Analysis of DP1180 Steel

Experimental and simulation of primary dendrite spacing in directional solidification of Al-7Si-0.36Mg alloy

Numerical modeling and simulation of water cooling-controlled solidification for aluminum alloy investment casting

Modeling Dendrite Coarsening and Remelting during Directional Solidification of Al-06wt.%Cu Alloy

Effect of casting speed on dendrite arm spacing of Mn13 steel continuous casting slab

Three-dimensional visualization and quantification of microporosity in aluminum castings by X-ray micro-computed tomography

Spacing Characterization in Al-Cu Alloys Directionally Solidified Under Transient Growth Conditions