Abstract:SnO2 has the advantages of excellent photostability and can be prepared at low-temperature below 200 degrees C.It is regarded as one of the excellent materials for the electron transport layer, and widely used in efficient andstable planar heterojunction perovskite solar cells. In this work, the low-cost, dense and uniform SnO2 electrontransport layer is prepared by spin coating at low temperature (150 degrees C) for perovskite solar cells with astructure of FTO/SnO2/CH3NH3PbI3 (MAPbI3)/Spiro-OMeTAD/Au. The crystallization and photoelectricproperties of SnO2 electron transport layers prepared at different concentrations (2.5%-10%) at 150 degrees C, and theinfluences of SnO2 electron transport layers on the formation of perovskite films and the performances ofperovskite solar cells are discussed. By analyzing the scanning electron microscope (SEM), ultraviolet-visiblelight absorption spectrum (UV-Vis) and transmission spectrum of the SnO2 film, it is found that the coverageand light transmittance of the substrate and band gap of the SnO2 film increase as the SnO2 content increases,while the absorbance decreases. By analyzing the SEM, UV-Vis, X-ray diffraction (XRD) and steady-statephotoluminescence spectrum (PL) analysis of the SnO2/MAPbI3 thin film, it is found that the MAPbI3deposited on the SnO2 layer with a concentration of 7.5% is uniform and pinhole-free, has the largest particlesize and the best crystallinity, as well as more effective charge extraction capability and transport capability.By analyzing the electrochemical impedance (EIS) and external quantum efficiency (EQE) of the device, theSnO2 electron transport layer with a concentration of 7.5% has better interface contact and lower interfaceresistance, which is beneficial to reducing the recombination of carriers and improving the photoelectricconversion capability, The perovskite solar cells based on SnO2 layer prepared with a concentration of 7.5%reaches a photoelectric conversion efficiency of 15.82% (Voc = 1.06 V, Jsc = 21.62 mA/cm2, FF = 69.40%), Afterstoring for 600 h in ambient air ((25 +/- 5) degrees C, RH>70%) without encapsulation, its efficiency remains 92% of theinitial efficiency. At the same time, we prepare flexible devices on flexible substrates (TIO/PEN) by using SnO2precursor with a concentration of 7.5%, which exhibits good photovoltaic performance and achieves aphotoelectric conversion efficiency of 13.12%, and storage time for 84 d in ambient air ((30 +/- 5) degrees C, RH>70%)without encapsulation, its efficiency remains 48% of the initial efficiency. The PCE retains 78% of the initialefficiency after 1000 bending cycles with a bending radius of 3 mm. The study of optimizing the concentrationof SnO2 has laid a foundation for improving the performance of flexible perovskite solar cells.

Facile Synthesis, Sintering, and Optical Properties of Single-Nanometer-Scale SnO2 Particles with a Pyrrolidone Derivative for Photovoltaic Applications

Fast and Clean Preparation of Highly Crystalline SnO2 Nanoparticles Incorporated in Amorphous Carbon, and Its Dye Removal Performance

Synthesis of hybrid amorphous/crystalline SnO2 1D nanostructures: investigation of morphology, structure and optical properties

Sub-2 Nm SnO2 Nanocrystals: A Reduction/oxidation Chemical Reaction Synthesis and Optical Properties

Facile Synthesis Of Monodisperse, Size-Tunable Sns Nanoparticles Potentially For Solar Cell Energy Conversion

Enhancing the Performance of Nanocrystalline SnO2 for Solar Cells through Photonic Curing Using Impedance Spectroscopy Analysis

Synproportionation Reaction for the Fabrication of Sn<sup>2+</sup> Self-Doped SnO<sub>2-x</sub> Nanocrystals with Tunable Band Structure and Highly Efficient Visible Light Photocatalytic Activity

Low-temperature preparation of SnO2 electron transportlayer for perovskite solar cells

Simultaneous Li-Doping and Formation of SnO2-Based Composites with TiO2: Applications for Perovskite Solar Cells

Synproportionation Reaction For The Fabrication Of Sn2+Self-Doped Sno2-X Nanocrystals With Tunable Band Structure And Highly Efficient Visible Light Photocatalytic Activity

Synthesis and applications of SnO nanosheets: parallel control of oxidation state and nanostructure through an aqueous solution route.

Low-temperature Preparation of SnO<sub>2</sub> Electron Transport Layer for Perovskite Solar Cells

Sequential Deposition of Diluted Aqueous SnO2 Dispersion for Perovskite Solar Cells

Synthesis and characterization of the doped/co‐doped SnO2 nanoparticles by the sol–gel method

Multifunctional Regulation of SnO 2 Nanocrystals by Snail Mucus for Preparation of Rigid or Flexible Perovskite Solar Cells in Air

Structural, Morphological and Optical Properties of Sn Doped Zinc Oxide Thin Films Synthesis by Sol-Gel Method for Photocatalytic Applications

Synthesis,structures and Luminescence Properties of SnO2 Nanoparticles

Synthesis, Photoluminescence and Photocatalytic Activity of Tetragonal SnO2 Prepared by Hydrothermal Sol-Gel Method

Facial Synthesis of SnO2 Nanoparticle Film for Efficient Fiber-Shaped Dye-Sensitized Solar Cells

Aqueous solution synthesis of SnO nanostructures with tuned optical absorption behavior and photoelectrochemical properties through morphological evolution.

Optimized SnO2 preparation and coherent interlayers for enhanced charge dynamics and efficient perovskite photovoltaics