Abstract:Most pipeline systems in dairy and food processing plants are cleaned by circulating cleaning solutions under pressure with a liquid pump. The flow of the circulated solutions is single-phase or flooded flow. Milking system pipelines are subject to special requirements which distinguish them from those in dairy and other food processing plants. Milking system pipelines are considerably larger in diameter than product lines in dairy plants because they must carry both milk and air in a stratified flow condition during the milking process. Milking machine Clean-In-Place (CIP) systems have historically used flooded flow to circulate cleaning solutions. The force to move liquid, however, is typically the vacuum provided by the same vacuum pump used during milking, rather than a positive pressure liquid pump. As the size and complexity of milking machines has increased in recent years, flooded flow CIP systems have become inadequate. The amount of water required to fully flood a milking system becomes impractical with very long and/or large diameter pipelines. The power available to achieve adequate flow velocity is also limited. Air admission has been used to produce two-phase (air/water) slug flow and overcome some of the limitations of fully flooded CIP. Cycled air admission can reduce the amount of water required for circulation and increase flow velocities and thus enhance mechanical cleaning action. Cycled air admission has been implemented in the field largely through trial and error methods. There has been a lack of fundamental design information and testing protocols for air-injected milking machine CIP systems. This has resulted in mixed success in the application of air injected systems. This paper summarizes both laboratory and field research conducted at the University of Wisconsin Milking Research and Instruction lab to provide basic information for the design of air injected CIP systems and methods for field assessment of these systems. Just as properly implemented air-injection can improve cleaning and sanitation in milking machines with less water and energy, so to it may have applications in the cleaning of other types of tube equipment.

Requirements for teat inspection and cleaning in automatic milking systems

Visual detection of technical success and effectiveness of teat cleaning in two automatic milking systems

Milking equipment for robotic milking

Conventional and Emerging Clean-in-Place Methods for the Milking Systems

Mastitis Control in Automatic Milking Systems

Understanding dynamic milking machine tests

Introduction of electronics into milking technology

A system for assessing cow cleanliness

Dumb animals and smart machines: the implications of modern milking systems for integrated management of dairy cows

The Role of the Cow in Automatic Teat Cup Attachment

Invited review: Udder health of dairy cows in automatic milking

Relationship between udder health and hygiene on farms with an automatic milking system

Technical design and assessment of tube equipment using two-phase flow for cleaning and disinfection

Design and manufacturing a washing unit for teat cups in the bucket milking system and it's effect on the produced milk quality

Influence of milking machines on mastitis

[The milking machine as a cause of severe agitation in cows (and the farmer) during milking]

ANALYSIS OF MODERN AUTOMATIC METHODS OF WASHING OF MILKING INSTALLATIONS

Short communication: The effect of premilking with a teat cup-like device, in a novel robotic rotary, on attachment accuracy and milk removal

Robotic milking in dairy farming

Operation of the milking equipment

Effects of milking machine settings and teat liners on bovine udder health