Abstract:Increasing levels of data are routinely collected on modern dairy farms. These include multiple variables measured by milking machine sensors and software and cow-attached sensor data, used predominantly for fertility and health monitoring. Following milking efficiency principles, including milking gently, quickly, and completely, there is utility in investigating how various milking machine settings affect gentleness of milking through a proxy measurement of cow comfort during milking. The use of leg-mounted accelerometers was investigated as a noninvasive labor-efficient means of estimating cow comfort on different automatic cluster remover (ACR) milk flow-rate switch-point settings. Accelerometer step count measurements during milking were collected from 37 cows divided into 2 groups allocated to either an ACR milk flow-rate switch-point setting of 0.2 kg/min or 0.8 kg/min for a 2-wk period and then crossed over to the other setting. Significantly more rear leg stepping occurred during daily milking (combined step count during a.m. and p.m. milkings) where the ACR activated at 0.2 kg/min (11.7 steps) compared with 0.8 kg/min (10.1 steps). Shorter milking interval between a.m. and p.m. milkings resulted in lower udder fill and reduced milk flow-rate. Under these lower udder fill conditions, rear leg movement, as an indicator of cow comfort, reduced when milk flow-rate switch-point for cluster removal increased from 0.2 kg/min (5.75 steps) to 0.8 kg/min (4.96 steps). There was no significant difference between stepping rates on both cluster removal settings during a.m. milkings. Similarly, no significant differences were noted in assessed postmilking teat condition, which was conducted after a.m. milking. The 0.2 kg/min setting extended total daily milking time by 70 s, resulting in lower mean flow-rates while producing similar milk yield. Higher vacuum levels at the teat-end were also recorded on this milking setting. This provides further incentive to consider cluster removal settings above 0.2 kg/min.

Understanding dynamic milking machine tests

Comparing the Performance of Automatic Milking Systems through Dynamic Testing Also Helps to Identify Potential Risk Factors for Mastitis

Influence of milking machines on mastitis

Effect of Milking Machine Design and Function on New lntramammary Infection

Effects of milking machine settings and teat liners on bovine udder health

Measurement of machine-induced changes in thickness of the bovine teat

[The milking machine as a cause of severe agitation in cows (and the farmer) during milking]

Mastitis Control in Automatic Milking Systems

Technical Development of Milking Machines

Operation of the milking equipment

Using infrared thermography to determine changes in teat skin surface temperature after machine milking in dairy cows

Simulation Tests of a Cow Milking Machine—Analysis of Design Parameters

Effects of machine milking on udder health in dairy ewes

A multi-valved milking machine cluster to control intramammary infection in dairy cows

Effect of hydraulic milking on milking performance, teat condition and lipolysis

Laboratory Tests to Optimize the Milking Machine Settings with Air Inlet Teat Cups for Sheep and Goats

Dumb animals and smart machines: the implications of modern milking systems for integrated management of dairy cows

Milking equipment for robotic milking

Measurement of cow comfort during milking on different cluster removal settings through the use of leg-mounted accelerometers