Abstract:The microstructure–property relation in ferroelectric/ferromagnetic composite is investigated in detail, exemplified by typical sol–gel-derived 0.3BTO/0.7NZFO ceramic composite. The effect of microstructural factors including intergrain connectivity, grain size and interfaces on the dielectric and magnetic properties of the composite prepared by conventional ceramic method and three-step sintering method is discussed both experimentally and theoretically. It reveals that the dielectric behavior of the composite is controlled by a hybrid dielectric process that combines the contribution of Debye-like dipoles and Maxwell–Wagner (M–W or interfacial) polarization. Enhanced dielectric, magnetic and conductive behaviors appear in the composite with better intergrain connectivity and larger grain size derived by sol–gel route and three-step sintering method. The effective permittivity contributed by Debye-like dipoles exhibits a value of ~130,000 in three-step sintered composite, which is almost the same as that in conventionally sintered one, but that contributed by M–W response is much smaller in the former. Compared with conventionally prepared samples, the relaxation time (τ) is 3.476 × 10−6 s, about one order of magnitude smaller, and the dc electrical conductivity is 3.890 × 10−3 S/m, one order of magnitude higher in three-step sintered composite. The minimum dielectric loss reveals almost the same (~0.2) for all samples, but shows distinguishable difference in low-frequency region. Meanwhile, an initial permeability of 84, twice as large as that of conventionally prepared composite and 56 % the value of single-phased NZFO ferrite (~150), and a saturation magnetization of 63.5 emu/g, 32 % higher than that of conventional one and approximately 84 % the value of single-phased NZFO ferrite (~76 emu/g), appear simultaneously in three-step sintered composite with larger grain size and better intergrain connectivity. It is clear that the discovery is helpful for establishing a more explicit view on the physics of multi-functional composite materials, while the composite with optimized microstructure is beneficial to be used as a high-performance material.

Phase formation, electric and magnetic properties of multiferroic 0.7Ba0.9Ca0.1TiO3-0.3Ni0.6Zn0.4Fe2O4 composites ceramics synthesized by the solid-state combustion technique

Electrical and magnetic properties of BaTiO3−(Ni0.3Zn0.7)Fe2.1O4 composites

PREPARATION AND PROPERTIES OF BaTiO_3/Ni_(0.5)Zn_(0.5)Fe_2O_4 COMPOSITE CERAMICS

Preparation of Nanoscale [(ba0.85ca0.15)0.995nd0.005](ti0.9hf0.1)o3 Ceramics Via Hydrothermal Method and Effect of Grain Size on Multifunctional Performance

Anomalous Conductivity Behavior Induced by in Situ Metastable Amorphous Phase in BaTiO3/Ni0.5Zn0.5Fe2O4 Ceramic Composite

Relation Between the Microstructure and the Electromagnetic Properties of BaTiO 3 /ni 0.5 Zn 0.5 Fe 2 O 4 Ceramic Composite

Preparation Of Fine-Grained Multiferroic Batio3-(Ni0.5zn0.5) Fe2o4 Ceramic Composites

Microstructure and Properties of Ni<sub>0.5</sub>Zn<sub>0.5</sub>Fe<sub>2</sub>O<sub>4</sub>-BaTiO<sub>3</sub> Ceramic

Ferroelectricity and Ferromagnetism in Fine-Grained Multiferroic Batio3/(Ni0.5zn0.5)Fe2o4 Composites Prepared by A Novel Hybrid Process

Ferroelectric Phase Transition and Electrical Properties of High-Tc PMN-PH-PT Ceramics Prepared by Partial Oxalate Route

Formation and Electromagnetic Properties of 0.1 BTO/0.9NZFO Ceramic Composite with High Density Prepared by Three‐Step Sintering Method

Preparation of 0.5pbtio_3/0.5nife_2o_4 Ceramic Composites by Sol-gel Method

Enhancing Electrical Properties of High-Curie Temperature Piezoelectric Ceramics BNT-PZT and Their Mechanism

Formation of sol-gel in situ derived BTO/NZFO composite ceramics with considerable dielectric and magnetic properties

Preparation of the Percolative Nickel-Zinc Ferrite/Barium Titanate Composite Ceramics with Liquid-Solid Hybrid Method

Phase/domain Structure and Enhanced Thermal Stable Ferro-/Pyroelectric Properties of (1-X)0.94na0.48 Bi0.44TiO3-0.06BaTiO3:xZnO Ceramics

Phase formation and performance of high Curie temperature Bi(Ni0.5Ti0.5)O3–BiFeO3–PbTiO3 ceramics

Multiferroic Properties of (1 −X)[0.94bi0.5na0.5tio3–0.06batio3]–xcofe2o4ceramics

Magnetic Properties of a Novel Ceramic Ferroelectric–Ferromagnetic Composite

Electrical Properties Of Low-Fire Ferroelectric Plus Ferrimagnetic Ceramic Composite

Preparation and Spontaneous Polarization–Magnetization of a New Ceramic Ferroelectric–Ferromagnetic Composite