Abstract:Objective: This experiment aimed to investigate the effects of bone conditions and osseointegration rates on the stress distribution of short implants using finite element analysis and also to provide some reference for the application of short implants from a biomechanical prospect. Materials and methods: Anisotropic jaw bone models with three bone conditions and 4.1 × 6 mm implant models were created, and four osseointegration rates were simulated. Stress and strain for the implants and jaws were calculated during vertical or oblique loading. Results: The cortical bone area around the implant neck was most stressed. The maximum von Mises stress in cortical bone increased with bone deterioration and osseointegration rate, with maximum values of 144.32 MPa and 203.94 MPa for vertical and inclined loading, respectively. The osseointegration rate had the greatest effect on the maximum principal stress in cortical bone of type III bone, with its value increasing by 63.8% at a 100% osseointegration rate versus a 25% osseointegration rate. The maximum and minimum principal stresses under inclined load are 1.3 ~ 1.7 and 1.4 ~ 1.8 times, respectively, those under vertical load. The stress on the jaw bone did not exceed the threshold when the osseointegration rate was ≥ 50% for Type II and 100% for Type III. High strain zones are found in cancellous bone, and the maximum strain increases as the bone condition deteriorate and the rate of osseointegration decreases. Conclusions: The maximum stress in the jaw bone increases as the bone condition deteriorates and the osseointegration rate increases. Increased osseointegration rate reduces cancellous bone strain and improves implant stability without exceeding the yield strength of the cortical bone. When the bone condition is good, and the osseointegration ratio is relatively high, 6 mm short implants can be used. In clinical practice, incline loading is an unfavorable loading condition, and axial loading should be used as much as possible.

Optimizing dental implant design: Structure, strength, and bone ingrowth

Model-based biomechanical dental implant optimization in bone-implant system

Using optimization approach to design dental implant in three types of bone quality - A finite element analysis

Applications To Implant Dentistry

Catastrophe under pressure

Shape Optimization Of Dental Implants

Optimum Selection of the Dental Implant Diameter and Length in the Posterior Mandible with Poor Bone Quality – A 3D Finite Element Analysis

Biomechanical effects of bone quality and design features in dental implants in long-term bone stability

Multi-objective optimization of custom implant abutment design for enhanced bone remodeling in single-crown implants using 3D finite element analysis

Novel design of additive manufactured hollow porous implants

Prognostic factors for survival in patients with hepatocellular carcinoma after percutaneous microwave ablation.

Three-dimensional finite element analysis of stress distribution on short implants with different bone conditions and osseointegration rates

Optimization of stress distribution of bone-implant interface (BII)

Novel Design and Finite Element Analysis of Diamond-like Porous Implants with Low Stiffness

Mechanical and modal analysis of different implant strategies for loss of three teeth with bone atrophy in the maxillary posterior region

Comparison of stress distribution in fully porous and dense-core porous scaffolds in dental implantation

Effect of Short Dental Implant Material on Bone Stress: An In Vitro Finite Element Analysis

Biomechanical and Mechanostat analysis of a titanium layered porous implant for mandibular reconstruction: The effect of the topology optimization design

Growth and cell wall changes in rice roots during spaceflight

Irregular Implant Design Decreases Periimplant Stress and Strain under Oblique Loading.

Implant Strength Contributes to the Osseointegration Strength of Porous Metallic Materials