Research on 3 D FBG accelerometer and demodulation method

Qiuming Nan,Lei Song

Abstract:1671-7694/2014/S12302(5) S12302-1 © 2014 Chinese Optics Letters Vibration monitoring is one of the most effective methods in mechanical equipment monitoring and fault diagnosis field. The vibration monitoring mainly uses the electromagnetic vibration sensors, such as piezoelectric sensor. Although the technology is well-developed with excellent performance, its disadvantages are poor ability to resist electromagnetic interference, signal not transmitted over long distance, difficult to achieve large-scale network. So, it is difficult to realize real-time and largescale monitoring for the vibration state of mechanical equipment in the flammable, explosive and electromagnetic interference situation[1,2]. Owing to many advantages of fiber Bragg grating (FBG) technology, since the emergence in late 70’s, though it has aroused a great concern, it has been developing very rapidly. After 2000, research and application of the technology have started in the vibration monitoring of mechanical equipment, and resulted in a few achievements[3,4]. But the existing FBG accelerometers are largely one-way, unable to meet the needs of three-dimensional vibration measurement. Then if one-way accelerometer is used, it requires at least three accelerometers for better functionality, which increases the cost of testing. Often, because of the installation space constraint, multiple sensors cannot be installed in the same monitoring point; eventually, testing data cannot reflect the real acceleration value in different directions of the monitoring point. However, so far, reports of 3D FBG accelerometer are rare; there is no report especially on 3D FBG accelerometer used in vibration monitoring of mechanical equipment. Hence, the research on the sensor is the focus of the paper[5–7]. In addition, in order to solve the problem of vibration signal demodulation speed, a light intensity demodulation method is adopted based on matched filter. But the method has one obvious disadvantage, namely, low measurement accuracy, which is caused by attenuation of light source and line loss. Solving of this problem is also considered in this paper. Figure 1 shows the 3D FBG accelerometer studied in this paper, which is composed of three unidirectional sensing units that are mutually vertical. Each sensing unit is composed of a base, an elastomer, a mass block and two FBGs, and its structure and principle are shown in Fig. 2. Two FBGs written in the same optical fiber are formed into precise matching by accurate fabrication process, and they are symmetrically fixed between the base and the mass block. In order to avoid dead zone, they are pre-stretched about 1 nm. When the sensor receives the vibration signal from the outside world, the mass supported by the elastic membrane vibrates up and down in order to drive the FBGs axial expansion, envelope area of reflection peaks of FBG1; and FBG2 Research on 3D FBG accelerometer and demodulation method

Physics,Engineering