Abstract:In deep underground engineering, circular roadways are widely used; many rock engineering problems can usually be simplified as mechanical analysis of rock structures with holes. To reveal the influence of intrahole reinforcement on the mechanical properties of rock with a single hole, this paper takes the single-hole rock-like material specimens with different reinforcement conditions as the research object. The RYL600 rock shear rheometer was used to conduct biaxial compression tests and, combined with HD industrial cameras and high-precision strain gauges, to study the effects of different reinforcement thicknesses and different lateral pressure on the mechanical properties of single-hole rock-like materials during the total stress and strain process. The thickness of the reinforced aluminum alloy pipe in the whole test is divided into four types: 0, 1, 1.5, and 2 mm. Under different reinforcement conditions, it is divided into 4 series of 0, 0.5, 1, and 1.5 MPa according to the different lateral pressure. Research shows the following: (1) Under the same lateral pressure, as the reinforcement thickness of the aluminum alloy tube increases, the reinforcement effect of the aluminum alloy tube on the specimen increases, and the strength of the reinforced specimen is increased by 1.42%~33.04% compared with the strength of the unreinforced specimen; under the same reinforced thickness of the aluminum tube, the peak strength of the specimen increases with the increase of lateral pressure, and the peak strength of the specimen with lateral pressure is 3.34%~50.26% higher than that of the specimen without lateral pressure. (2) Increasing the lateral pressure can significantly reduce the primary tensile cracks of the specimen. As the reinforcement thickness increases, the primary tensile cracks and remote cracks of the specimen are significantly reduced, and the failure surface of the specimen gradually tends to the middle of the sample. (3) The failure modes of specimens with holes can be divided into five types: single bevel type I, single bevel type II, single bevel type III, bevel T type, and single part shear type. All of these five failure modes are shear cracks that develop into fracture surfaces, while remote cracks and primary tensile cracks do not develop into fracture surfaces.

Reinforcement of rock mass with cross-flaws using rock bolt

Experimental and numerical investigations on mechanical property and reinforcement effect of bolted jointed rock mass

Study on the Bolt-mesh-anchor Surrounding Mechanism of a Roadway in a Soft and Thick Rock Seam

Experimental Studies on Cracking and Local Strain Behaviors of Rock-Like Materials with a Single Hole before and after Reinforcement under Biaxial Compression

Shear Behavior of Bolt-Reinforced Joint Rock Under Varying Stress Environment

Strength and deformation behaviors of bedded rock mass under bolt reinforcement

Cracking Behavior and Acoustic Emission Characteristics of Rock Containing a Single Preexisting Flaw

Development of a Unified Rock Bolt Model in Discontinuous Deformation Analysis

Experimental study on mechanical properties of fractured rock mass under different anchoring modes

Analytical Approach in Optimising Selection of Rebar Bolts in Preventing Rock Bolting Failure

Experimental Study on the Mechanical Behavior of Rock Bolts Subjected to Complex Static and Dynamic Loads

Laboratorial Tests and Numerical Modeling of Rock Bolts Bonded by Different Materials

Rock bolts under cyclic loading: Mechanical performance and damage assessment by acoustic emissions

Pullout Performances of Grouted Rockbolt Systems with Bond Defects

Analytical studying the axial performance of fully encapsulated rock bolts

Study on the anchorage mechanism and roof stability control technology of bolts in fractured or weak surrounding rock

Strength, deformation and failure behavior of bolted rock-like specimen with multiple cracks under uniaxial compression by particle flow simulation

Experimental study and stress analysis of rock bolt anchorage performance

Multi-scale experimental study on the failure mechanism of high-strength bolts under highly mineralized environment

Experimental Research on the Mechanical Performance of the Bolted Rock under Lateral Impact Load: Effect of Prestress, Body Material, and Anchorage Style

Field experimental study on the pull-out characteristics of a new type of expanding shell bolt