Abstract:A glassy carbon electrode (GCE) is modified with MIP‐GO composite, and it binds E2 due to specific binding sites and is detected by voltammetric detection. Furthermore, by increasing the concentration of E2, the peak current intensity increases simultaneously. This research article demonstrates the synthesis, characterization, and electrochemical evaluation of a molecularly imprinted polymer (MIP) on the surface of silanized graphene oxide (silanized GO), which is nanostructured and used to quantify 17‐estradiol (E2) in wastewater. As characterization methods, X‐ray diffraction (XRD), Raman spectroscopy, dynamic scattering light (DSL), scanning electron microscope (SEM), and Fourier transform infrared spectroscopy (FTIR) were utilized to examine the synthesized GO, silanized GO, MIP‐GO composite, and non‐imprinted polymer (NIP)–GO (NIP‐GO) composite. FTIR results confirmed the successful synthesis of GO composites. Raman study confirmed the synthesis of monolayer silanized GO, MIP‐GO composite, and NIP‐GO composite. Surface morphology revealed that after polymerization, the surface of silanized GO sheet‐like morphology is covered with nanoparticles. Adsorption kinetics studies revealed that adsorption follows the pseudo‐second‐order kinetics. Further, we studied the performance of a MIP‐GO‐based sensor by optimizing the effects of pH, scan rate, and incubation period. The linear calibration was achieved between the oxidation peak current and E2 concentration from 0.1 to 0.81 ppm, with a detection limit of 0.037 ppm. The selectivity of the MIP‐GO composite was also checked by using other estrogens, and it was found that E2 is 3.3, 0.5, and 1.4 times more selective than equilin, estriol, and estrone, respectively. The composite was successfully applied to the wastewater samples for the detection of E2, and a good percentage of recoveries were achieved. It suggests that the reported composite can be applied to real samples. Practitioner Points An innovative electrochemical sensor was developed for selective detection of 17‐estradiol through molecularly imprinted polymer fabricated on the surface of silanized GO (MIP‐GO composite). The developed method was comprehensively validated and found to be linear in the range of 0.1 to 0.8 ppm of 17‐estradiol, with 0.037 ppm of limit of detection and 0.1 ppm of limit of quantification, respectively. The developed MIP‐GO‐composite‐based electrochemical sensor was found 3.3, 0.5, and 1.4 times more selective for 17‐estradiol than equiline, estriol, and estrone, respectively. The applicability of a developed sensor was also checked on wastewater samples, and a good percent recovery was obtained.

Portable smartphone-enabled dydrogesterone sensors based on biomimetic polymers for personalized gynecological care

Salivary Cortisol Determination on Smartphone-Based Differential Pulse Voltammetry System

Detection of progesterone in aqueous samples by molecularly imprinted photonic polymers

A wearable aptamer nanobiosensor for non-invasive female hormone monitoring

Development of a molecularly imprinted polymer on silanized graphene oxide for the detection of 17‐estradiol in wastewater

Sandpaper-templated Stretchable Immunosensing Electrodes for Sub-picomolar Progesterone Detection

Development of Electrochemical Immunosensors for Early Diagnosis of Polycystic Ovary Syndrome (PCOS), and Their Potential Mobile Phone Application

Advances in molecularly imprinted polymers-based electrochemical sensors for the detection of gonadal steroid hormones

Polyaniline Entrapped Water-Dispersible 3MPA-ZnSe Quantum Dots and Their Application for the Development of an Enzymatic Electrochemical Nanobiosensor for the Detection of 17β-Estradiol, an Endocrine-Disrupting Compound

Electro-responsive Molecularly Imprinted Polymers (E-MIPs) for Rapid Detection of Progesterone in Human Serum Samples

Electrochemical Sensor Based on Molecularly Imprinted Membranes at Platinum Nanoparticles-Modified Electrode for Determination of 17Β-Estradiol.

Wearable and Recyclable Epinephrine Biosensors Based on Molecular Imprinting Polymer Modified Organic Electrochemical Transistors

Surfactant and polymer layered carbon composite electrochemical sensor for the analysis of estriol with ciprofloxacin

Synergistic recognition and electrochemical sensing of 17β-Estradiol using ordered molecularly imprinted polymer-graphene oxide-silver nanoparticles composite films

Electroactive Molecularly Imprinted Polymer Nanoparticles (eMIPs) for Label-free Detection of Glucose: Toward Wearable Monitoring

Aptamer-based label-free impedimetric biosensor for detection of progesterone

Application of new aptasensor modified with nanocomposite for selective estradiol valerate determination in pharmaceutical and real biological samples

Surface Plasmon Resonance Sensor for Femtomolar Detection of Testosterone with Water-Compatible Macroporous Molecularly Imprinted Film.

Tip-Enhanced Sub-Femtomolar Steroid Immunosensing via Micropyramidal Flexible Conducting Polymer Electrodes for At-Home Monitoring of Salivary Sex Hormones

A competitive-type photoelectrochemical aptasensor for 17 beta-estradiol detection in microfluidic devices based on a novel Au@Cd:SnO2/SnS2 nanocomposite

Reduced Graphene Oxide-Platinum Nanoparticles Composites Based Imprinting Sensor for Sensitively Electrochemical Analysis of 17Β-Estradiol