Microstructure evolution, strength-ductility synergy and fracture mechanisms of Cu-18Sn-0.3Ti alloy prepared using Direct Current assisted Hot Pressed sintering and conventional solution treatment
Lin Shi,Juntao Zou,Lixing Sun,Jing Chen,Junsheng Cheng,Hangyu Xue,Xianglong Li,Tong Dang,Yuxuan Wang,Dazhuo Song,Yihui Jiang,Zhiwei Zhang,Yuchen Song
DOI: https://doi.org/10.1016/j.matchar.2023.113346
IF: 4.537
2023-11-01
Materials Characterization
Abstract:Based on micron atomized spherical Cu-18Sn-0.3Ti alloy powders, the Cu-18Sn-0.3Ti alloy with an elongation of 23.4%, an ultimate tensile strength of 507.2 MPa and a yield strength of 229.4 MPa was prepared using Direct Current assisted Hot Pressed sintering (DCHP) and conventional solution treatment. The microstructure evolution mechanism of alloy during DCHP, the strength-ductility synergy and fracture mechanisms of solution treated DCHP (ST-DCHP) samples were systematically investigated. The results show that, under the synergistic effect of Joule heat, electron wind force and external load of DCHP, dislocations were consecutively generated and consumed as the driving force of dynamic recrystallization, fine equiaxed grains and a large number of annealing twins were formed, the prior particle boundaries (PPBs) of alloy powders gradually disappeared and good sintering necks were formed, which played key roles in improving the strength of alloy. Simultaneously, the δ phase was segregated from grain boundaries to PPBs during DHCP. During the subsequent solution treatment, the phase transformation of δ phase occurred, the β, γ and ε phases which were conducive to the plastic deformation of alloy were generated inside δ phase, resulting in a change in the fracture mechanism inside powders and at sintering necks. The high fraction of high-angle grain boundaries (HAGBs) was considered as the main reason for inducing the formation of high-density deformation twins with different directions inside fine α grains, which greatly improved the ductility of alloy. The strengthening contributions of microstructure were also evaluated, and the calculated yield strength was well consistent with the experimental ones. The results provide the theoretical guidance for the preparation of Cu-Sn-Ti alloy with higher Sn content and lay a foundation for the preparation of Nb3Sn superconducting wires with higher critical current density.
materials science, multidisciplinary,metallurgy & metallurgical engineering, characterization & testing