Abstract:Recently, a new type of carbonate reservoir, the fault-karst carbonate reservoir has attracted lots of attention, which usually develops large-scale karst caves, vugs, and high-angle fractures along the strike-slip fault zones. Despite containing plenty of hydrocarbon resources, the complex geological structure and the strong heterogeneity make it difficult to develop this kind of reservoir effectively and economically. To perform water-drive experiments and investigate the production performance under different well patterns and injection-production modes, two 2D visualized physical models were designed and fabricated based on the typical geological structures of the fault-karst carbonate reservoir in the vertical and horizontal directions, respectively. According to the experimental results, the average oil recovery can reach 62.96% for the vertical model and 58.18% for the horizontal model. In fact, gravity effect due to density differences can greatly improve the displacement efficiency of oil by water in the vertical direction; hence, the horizontal heterogeneity would have a relatively greater impact on waterflooding development. When water is injected into the reservoir from the middle section, a large amount of un-swept oil will remain at the bottom fractures. Thus, the Bottom Injection & Top Production (BI & TP) mode should be adopted in all well patterns to increase recovery. If non-inverted well patterns are employed, dominant water channeling would form quickly in the horizontal direction, and the swept area will be hugely limited. Therefore, the Center Injection & Edge Production mode (inverted well patterns) is recommended for water-drive applications. It is also found that the water breakthrough time negatively correlates with the effective flooding time for the vertical model and the total oil recovery is more impacted by water breakthrough for both models. Additionally, the oil-water exchange ratio is introduced to evaluate the utilization efficiency of injected water. Calculation results have shown that the BI & TP mode is optimal in terms of either total recovery or oil-water exchange ratio in the vertical direction, but the well pattern layout in the horizontal direction could impact the oil recovery and oil-water exchange ratio, which, in turn, affect the project economics. This study provides novel insights for optimizing well patterns and waterflooding measures in actual fault-karst carbonate reservoirs.

Simulation of reservoir dynamic damage and influencing factors of horizontal wells in heterogeneous carbonate reservoirs

Numerical simulation of the temporal and spatial evolution of sandstone pore type reservoir damage types and severity

Production Performance Simulation of the Fractured Horizontal Well Considering Reservoir and Wellbore Coupled Flow in Shale Gas Reservoirs

Production performance simulation of a horizontal well in a shale gas reservoir considering the propagation of hydraulic fractures

Formation damage simulation of a multi-fractured horizontal well in a tight gas/shale oil formation

Simulation of the Production Performance of Fractured Horizontal Wells in Shale Gas Reservoirs Considering the Complex Fracture Shape

A semi-analytical pressure model of horizontal well with complex networks in heterogeneous reservoirs

Investigation on water-drive performance of a fault-karst carbonate reservoir under different well patterns and injection-production modes based on 2D visualized physical models

Analysis and Optimization of Influential Factors on Horizontal Well Staged Acidizing

Impact of cross-flow on well production in shale reservoir considering vertical variation of reservoir and fracture properties: Model and field application

Integration research of seismic data and logging for hydraulic fracturing in ultra-deep carbonate reservoirs with faults

Horizontal Well Fracturing Technology for Reservoirs with Low Permeability

Numerical Simulation of Well Type Optimization in Tridimensional Development of Multi-Layer Shale Gas Reservoir

Simulation of Key Influencing Factors of Hydraulic Fracturing Fracture Propagation in a Shale Reservoir Based on the Displacement Discontinuity Method (DDM)

Simulation of Production Dynamics after Reservoir Stimulation in Hydrate Reservoirs Considering Complex Fracture Morphology

Numerical study of hydraulic fractures propagation in deep fracture-cavity reservoir based on continuous damage theory

Numerical Simulation of Hydrate Dissociation Behaviors in Hydrate Reservoir with Different Properties during Horizontal Well Drilling

Research on the Law of Crack Propagation in Oil Well Fracturing Process

Simulation and Control Strategies for Longitudinal Propagation of Acid Fracture in a Low-Permeability Reservoir Containing Bottom Water

Physical Simulation Experiments of Hydraulic Fracture Initiation and Propagation under the Influence of Deep Shale Natural Fractures

Simulation of volumetric acid fracturing fracture in low permeability carbonate rock