Abstract:Micro-milling is extremely paramount to fabricating micro-scaled components, requiring high quality and low setup cost. However, with the low stiffness of micro-milling systems, the uncontrolled finished surface and vulnerable wearing tools must be addressed to achieve ultra-precision processing for the thin-wall micro-structure. This paper explored the surface formation mechanism based on dual-direction vibration-assisted (DVA) micro-milling (micro-milling with vibration signals respectively applied in the feed direction and perpendicular to the feed direction) and verified the effectiveness in back chipping, analyzing the impact on chips and tool life-lengthening effect. Initially, an active vibration-assisted signal was added to the feed direction, and the integrity and quality of the machined surface model were examined. Furthermore, two groups of experiments using a Co41Cr16Ni15 double-edged end mill to micro-milling Ti6Al4V surface were carried out, compared with conventional micro-milling, analyzing the effect of the vibration-assisted device on the integrity and quality of the bottom surface of the micro-groove, and establishing a deterministic vibration-assisted micro-milling system. Finally, the effects of vibration assistance on surface topography, chip topography, and micro-milling tool runout were determined. As a result, vibration assistance improved the micro-step structure on both sides of the thin-wall micro-structure surface caused by tool eccentricity and changed the surface morphology of the groove bottom. The experiment results showed that the form deviation of the vibration-assisted micro-milling surface was less than 101 nm SPV and surface roughness was also below 25 nm RMS. Surface formation mechanism based on the vibration-assisted micro-milling system was explored to reveal that vibration assistance improves surface integrity and quality, and sharply reduced the tool's runout rate.

A review on dynamics in micro-milling

Machining dynamics and chatters in micro-milling: A critical review on the state-of-the-art and future perspectives

Review of dynamic issues in micro-end-milling

A review on micro-milling: recent advances and future trends

Dynamics Design Optimization and Experimental Validation of a Miniaturized Machine Tool for Micro-Milling.

A review of chatter vibration research in milling

A dynamics-driven approach to the design of precision machine tools for micro-manufacturing and its implementation perspectives

Dynamic Modeling for Chatter Analysis in Micro-Milling by Integrating Effects of Centrifugal Force, Gyroscopic Moment, and Tool Runout

Recent Research Advances of Whole Machine Tool Dynamics

A State-of-the-Art Review on Chatter Stability in Machining Thin−Walled Parts

A review on theories/methods to obtain surface topography and analysis of corresponding affecting factors in the milling process

Precision micro-milling process: state of the art

Investigation on dynamic tool deflection and runout-dependent analysis of the micro-milling process

Advances in micro milling: From tool fabrication to process outcomes

A Systematic Review of Micro-Texture Formation Based on Milling: from Mechanism, Existing Techniques, Characterization to Typical Applications

An improved time-varying stability analysis of micro milling considering tool wear

Mechanism of dual-direction vibration-assisted (DVA) micro-milling in surface formation considering the tool life-lengthening effect on the Ti6Al4V: design and experiment

Progress of Cutting Force Modelling in Micromilling

Investigation on the Tool Wear Suppression Mechanism in Non-Resonant Vibration-Assisted Micro Milling

Study on Micro-diameter Milling Tool and Micro-milling Technology

Review of Advances in tool condition monitoring techniques in the milling process