Abstract:Experimental and numerical investigations on forced convection heat transfer of carbon dioxide at supercritical pressures in a prototypic printed circuit heat exchanger under both cooling and heating conditions have been performed in this present study. The experiment test section has nine semi-circular channels with a hydraulic diameter of 1.16 mm and a length of 0.5 m. Primary operational parameters include inlet pressure of 7.5-10 MPa, mass fluxes of 326 kg/m(2) s and 762 kg/m(2) s, inlet temperatures from 10 degrees C to 90 degrees C and the average heat flux was 30 kW/m(2). Beyond reproducing the regular experimental cases, numerical modeling also implemented higher heat fluxes of 60 kW/m(2) and 90 kW/m(2) in order to investigate the effect of heat flux. Good agreement was found between the experiments and FLUENT simulations using an SST k-w model with the near-wall region being completely resolved. The distinctive behavior of convection heat transfer at supercritical pressures between heating and cooling modes was systematically analyzed. A more physically reasonable property-averaging technique, Probability Density Function (PDF)-based time-averaged property, was developed to account for the effect of nonlinear dependency of properties on instantaneous local temperature. Furthermore, experimental and computational data were compared to empirical predictions by the Dittus-Boelter and Jackson correlations. The results showed that Dittus-Boelter correlation has better precision for the average value of the predicted heat transfer coefficient but cannot take account of the effect of heat flux. In contrast, the Jackson correlation, with property ratio correction terms to account for the distribution of the properties in the radial direction, could predict the distinction of heat transfer characteristics under heating and cooling conditions. However, it overestimates the average value of heat transfer coefficient in the whole range of the experiment conditions. Finally, a new correlation evaluated by PDF-based time-averaged properties for forced convection heat transfer of CO2 in both heating and cooling mode at supercritical pressures was developed. Comparison of experimental and computational data with the prediction results by the new developed correlation reveals that it works quite well; i.e., more than 90% data in either heating or cooling mode with various heat fluxes are predicted within an accuracy of +/- 25%. (C) 2011 Elsevier Masson SAS. All rights reserved.

On the mass transfer of supercritical fluids, specifically super critical CO 2 : An overview

Frictional Resistance Investigation of Sco2 and a Semi-Empirical Friction Factor Correlation Based on Wall-of-the-law

Physicochemical Principles of Extraction with Supercritical Gases

Numerical Investigation of Different Heat Transfer Behaviors of Supercritical CO2 in a Large Vertical Tube

Development of a New Forced Convection Heat Transfer Correlation for CO2 in Both Heating and Cooling Modes at Supercritical Pressures

Experimental and Numerical Investigation of Convective Heat Transfer of Supercritical Carbon Dioxide at Low Mass Fluxes

Supercritical CO2 as heat transfer fluid: A review

Study of Convection Heat Transfer of CO2 at Supercritical Pressures During Cooling in Fluted Tube-in-tube Heat Exchangers

Simulations of CO2 Dissolution in Porous Media Using the Volume-of-Fluid Method

Reynolds-Averaged Navier-Stokes Equations Describing Turbulent Flow and Heat Transfer Behavior for Supercritical Fluid

Numerical Investigation of Heat Transfer Characteristics of scCO2 Flowing in a Vertically-Upward Tube with High Mass Flux

Research Progress of Industrial Application Based on Two-Phase Flow System of Supercritical Carbon Dioxide and Particles

Direct Numerical Simulation of Supercritical CO2 Near the Critical Point Flowing over a Single Stefan Flow-Affected Spherical Particle

Molecular Dynamics Method for Supercritical CO2 Heat Transfer: A Review

Research of Heat Transfer Characteristics of Supercritical CO2 in Spiral Tube Heat Exchangers

Special heat transfer characteristics of supercritical CO2 flowing in a vertically-upward tube with low mass flux

Supercritical carbon dioxide heat transfer in horizontal tube based on the Froude number analysis

Numerical Simulation on Characteristics of Hydrodynamics, Interphase and Wall to Bed Heat Transfer in a Pseudo 2D Spouted Bed Using Supercritical CO2 As Fluidizing Agent

Thermal-Mechanical Effects and Near-Critical Fluid Dynamic Behaviors in Micro-Scale

General Heat Transfer Correlations for Supercritical Carbon Dioxide Heated in Vertical Tubes for Upward and Downward Flows

Experiments and Heat Transfer Correlation Validations of Low-Parameter Region of sCO2 Flow in a Long Thin Vertical Loop