Abstract:The proportion of double helices in starches from a series of pea [rb, rug4-b, rug3-a, and lam-c mutants, and the wild type (WT) parental line], potato and maize (normal and low amylose), and wheat (normal) lines, ranged from about 30-50% on a dry weight basis. In relatively dry starch powders, only about half of the double helices were in crystalline order, this proportion being higher for A-type than for B-type starches. Using starch from WT pea as an example, it was found that increasing water content results in an increase in total crystallinity. When the water content was raised to a level similar to that in excess water, the proportion of crystallinity was close to the proportion of double helices (DH). Measuring crystallinity in starches with a high water content is difficult using traditional methods such as x-ray diffraction. A method was developed, therefore, for determining starch structural characteristics in excess water by measuring the enthalpy of gelatinization transition in quasi-equilibrium differential scanning calorimetry (DSC) experiments. It is suggested that DH% = DeltaH(sp)/DeltaH(DH) x 100%, where DeltaH(sp) and DeltaH(DH) represent the specific enthalpies of gelatinisation transition, DeltaH(sp) being measured as J/g dry starch weight and DeltaH(DH) as J/g DH, in starch. Studies on potato and maize starches in excess water and in 0.6M KCl showed, respectively, that DeltaH(DH) was 36.3 and 35.6 J/g for B-type polymorphs and 33.0 and 35.0 J/g for A-type polymorphs. For C-type starches, such as those from pea, intermediate values of DeltaH(DH), related to the proportions A-/B-polymorphs, should be used. The type of crystallinity in starch can be determined by the shift in peak temperature for thermograms in excess water and in excess 0.6M KCl. For B-polymorphs this shift was found to be approximately 2-3 degrees C and for A-polymorphs approximately 7-12 degrees C. The ratio between ordered areas with both A- and B-polymorphs can be determined from the enthalpies of disruption of each area. These enthalpies can be obtained by deconvolution of bimodal thermograms produced by C-type starches in excess 0.6M KCl. This methodical approach can be applied to all starches that give a sharp gelatinisation thermogram in excess water. Using a range of methods, including DSC, it was found that starch granules from the mutant peas are constructed in a similar way to those from the WT, with B-polymorphs in the centre and A-polymorphs at the periphery of all granules. The proportion of A/B-polymorphs, however, differed between the mutants. It was found that in addition to increasing the total crystallinity, increasing the water content within the granules also resulted in an increase in the proportion of B-polymorphs.

Direct link between specific structural levels of starch and hydration properties

Interrelating Grain Hardness Index of Wheat with Physicochemical and Structural Properties of Starch Extracted Therefrom

Effect of plasma-activated water on the formation of endogenous wheat starch-lipid complexes during extrusion

Effect of Shearing and Annealing on the Pasting Properties of Different Starches

Effect of the phytate and hydrogen peroxide chemical modifications on the physicochemical and functional properties of wheat starch.

Gelatinization, Rheological and Retrogradation Behaviors of Waxy Rice Starch Affected by Gelatin Emulsion and Regulation Mechanism

Extrusion Modification of Wheat Bran and Its Effects on Structural and Rheological Properties of Wheat Flour Dough

Reduction of starch granule surface lipids alters the physicochemical properties of crosslinked maize starch

Fructooligosaccharides Impact on the Hydration and Retro-Gradation of Wheat Starch and Gel

Exploring the relationship between starch structure and physicochemical properties: The impact of extrusion on highland barley flour

Enzymatic modification lowers syneresis in corn starch gels during freeze-thaw cycles through 1,4-α-glucan branching enzyme

Effect of protein on the gelatinization behavior and digestibility of corn flour with different amylose contents

High Pressure/temperature Pasting and Gelling of Starch Related to Multilevel Structure-Analyzed with RVA 4800.

Investigating the Impact of Moisture Levels on Structural Alterations and Physicochemical Properties of Cassava Flour through Extrusion: A Comprehensive Study

Changes in the Crystallinity Degree of Starch Having Different Types of Crystal Structure after Mechanical Pretreatment

Structural studies of starches with different water contents

Modification of Starches with Different Amylose/Amylopectin‐Ratios Using the Dual Approach with Hydroxypropylation and Subsequent Acid‐Thinning—Impacts on Morphological and Molecular Characteristics

Insight into the relationship between the starch crystalline structure and textural quality and physicochemical properties of reconstituted rice: Influence of feed moisture content

The changed multiscale structures of tight nut (Cyperus esculentus) starch decide its modified physicochemical properties: The effects of non-thermal and thermal treatments

The Influence of Processing Using Conventional and Hybrid Methods on the Composition, Polysaccharide Profiles and Selected Properties of Wheat Flour Enriched with Baking Enzymes

Effect of wheat dextrin on corn flour extrusion characteristics