Abstract:The treatment of nanoparticle (NP) polluted aqueous suspensions by flotation can be problematic due to the low probability of collision between particles and bubbles. To overcome this limitation, the present work focuses on developing an enhanced flotation technique using the surface-functionalized micro-bubbles - colloidal gas aphrons (CGAs). The CGA generator was adapted to be air flow rate controlled based on the classical Sebba system; thus it could be well adopted in a continuous flotation process. Cetyl trimethylammonium bromide (CTAB) and sodium dodecyl sulfate (SDS) were employed for CGA creation. Positively surface-charged CTAB-CGAs (similar to 44.1 mu m in size) and negatively surface-charged SDS-CGAs (similar to 42.1 mu m in size) were produced at the optimum stirring speed of 8000 rpm. The half-life of CGAs varied from 100 s to 340 s under the tested conditions, which was largely sufficient for transferring CGAs from bubble generator to flotation cell. The air flow led to less stable CTAB-CGAs but apparently enhanced the stability of SDS-CGAs at higher air flow rates. In the presence of air flow, the drainage behavior was not much related to the type of surfactants. The continuous CGA-flotation trials highlighted the effective separation of silica nanoparticles - the removal efficiencies of different types of SiO2 NPs could reach approximately 90%-99%; however, at equivalent surfactant concentrations, no greater than 58% of NPs were removed when surfactants and bubbles were separately added into the flotation cell. The SiO2 NPs with small size were removed more efficiently by the CGA-flotation process. For the flotation with CTAB-CGAs, the neutral and basic initial SNP suspension was recommended, whereas the SDS-CGAs remained high flotation efficiency over all investigated pH. The good performance of CGA-flotation might be interpreted: most of the surfactant molecules well covered/coated on the surfaces of stable CGAs and thus fully contacted with NPs, resulting in the efficient utilization of surfactants. (C) 2017 Elsevier Ltd. All rights reserved.

Mineral-mineral particle collisions during flotation remove adsorbed nanoparticle flotation collectors

Effect of Grinding Media on the Flotation Behavior of Fluorite Using Sodium Oleate As a Collector

Surface-modified Microbubbles (colloidal Gas Aphrons) for Nanoparticle Removal in a Continuous Bubble Generation-Flotation Separation System.

Polyaluminum Chloride-Functionalized Colloidal Gas Aphrons for Flotation Separation of Nanoparticles from Water.

Effects of Pure and Modified Nanobubbles on the Reverse Flotation of Kaolinite from Hematite

Choosing mineral flotation collectors from large nanoparticle libraries

The flotation behaviour of N-(3-aminopropyl)-dodecanamide on three aluminosilicates

In Situ Adsorption of Mixed Anionic/Cationic Collectors in a Spodumene-Feldspar Flotation System: Implications for Collector Design

Interaction mechanism of interfacial nano-micro bubbles with collectors and its effects on the fine apatite flotation

Towards high throughput screening of nanoparticle flotation collectors

Nanobubble-enhanced flotation of ultrafine molybdenite and the associated mechanism

Improving micro-fine mineral flotation via micro/nano technologies

Microscale insights into the influence of grinding media on spodumene micro-flotation using mixed anionic/cationic collectors

Flotation Performance of Coal: Investigating the Synergistic Effects of Particle Size and Shape, and the Influence of Geometric Elements

Froth Flotation of Mineral Particles: Mechanism

Nanoparticle depressants in froth flotation ŌĆō the effect of colloidal silica with different size and surface modifications on the selective separation of semi-soluble salt type minerals

Aggregation of ultra-fine scheelite particles induced by hydrodynamic cavitation

Adsorption Mechanism of New Mixed Anionic/cationic Collectors in a Spodumene-Feldspar Flotation System

On the Use of Styrene-Based Nanoparticles to Mitigate the Effect of Montmorillonite in Copper Sulfide Recovery by Flotation

Removal of Polystyrene Nanoplastic Beads Using Gravity-Driven Membrane Filtration: Mechanisms and Effects of Water Matrices

Parameters of Collision and Adhesion Process Between a Rising Bubble and Quartz in Long-Chain Amine Solution and Their Correlation with Flotation