Abstract:Proton exchange membranes (PEMs) are often used in microbial fuel cells (MFCs) to separate the liquid in the anode and cathode chambers while allowing protons to pass between the chambers. However, negatively or positively charged species present at high concentrations in the medium can also be used to maintain charge balance during power generation. An anion exchange membrane (AEM) produced the largest power density (up to 610 mW/m2) and Coulombic efficiency (72%) in MFCs relative to values achieved with a commonly used PEM (Nafion), a cation exchange membrane (CEM), or three different ultrafiltration (UF) membranes with molecular weight cut offs of 0.5K, 1K, and 3K Daltons in different types of MFCs. The increased performance of the AEM was due to proton charge-transfer facilitated by phosphate anions and low internal resistance. The type of membrane affected maximum power densities in two-chamber, air-cathode cube MFCs (C-MFCs) with low internal resistance (84-91 omega for all membranes except UF-0.5K) but not in two-chamber aqueous-cathode bottle MFCs (B-MFCs) due to their higher internal resistances (1230-1272 omega except UF-0.5K). The UF-0.5K membrane produced very high internal resistances (6009 omega, B-MFC; 1814omega, C-MFC) and was the least permeable to both oxygen (mass transfer coefficient of k(O) = 0.19 x 10(-4) cm/s) and acetate (k(A) = 0.89 x 10(-8) cm/s). Nafion was the most permeable membrane to oxygen (k(O) = 1.3 x 10(-4) cm/s), and the UF-3K membrane was the most permeable to acetate (k(A) = 7.2 x 10(-8) cm/s). Only a small percent of substrate was unaccounted for based on measured Coulombic efficiencies and estimates of biomass production and substrate losses using Nafion, CEM, and AEM membranes (4-8%), while a substantial portion of substrate was lost to unidentified processes for the UF membranes (40-89%). These results show that many types of membranes can be used in two-chambered MFCs, even membranes that transfer negatively charged species.

Electricity and catholyte production from ceramic MFCs treating urine

Effect of simple interventions on the performance of a miniature MFC fed with fresh urine

Miniaturized Ceramic-Based Microbial Fuel Cell for Efficient Power Generation From Urine and Stack Development

Ion Exchange Membrane Cathodes For Scalable Microbial Fuel Cells

Tubular ceramic performance as separator for microbial fuel cell: A review

A Comprehensive Study of Custom-Made Ceramic Separators for Microbial Fuel Cells: Towards “Living” Bricks

Modification of clayware ceramic membrane for enhancing the performance of microbial fuel cell

Tubular Membrane Cathodes for Scalable Power Generation in Microbial Fuel Cells.

Characterization and application of novel fly ash blended ceramic membrane in MFC for low-cost and sustainable wastewater treatment and power generation

Impact of disinfectant on the electrical outputs of urine-fed ceramic and membrane-less microbial fuel cell cascades

Microbial Fuel Cell Using a Novel Ionic Liquid-Type Membrane–Cathode Assembly for Animal Slurry Treatment and Fertilizer Production

Response of ceramic microbial fuel cells to direct anodic airflow and novel hydrogel cathodes

Effect of Carbon Materials As Cathode on Wastewater Treatment and Bioelectricity Generation in a Double Chambered Microbial Fuel Cell

Integration of Microbial Fuel Cell with Independent Membrane Cathode Bioreactor for Power Generation, Membrane Fouling Mitigation and Wastewater Treatment

Power generation using different cation, anion, and ultrafiltration membranes in microbial fuel cells

Electronic faucet powered by low cost ceramic microbial fuel cells treating urine

Catalytic membrane cathode integrated in a proton exchange membrane-free microbial fuel cell for coking wastewater treatment

Self-stratifying microbial fuel cell: The importance of the cathode electrode immersion height

Performance evaluation of microbial fuel cell using a radiation synthesized low density polyethylene-grafted-poly (glycidyl methacrylate-co-vinyl acetate) as a proton exchange membrane

High Electric Production by Membraneless Microbial Fuel Cell with Up Flow Operation Using Acetate Wastewater

Bioelectricity production from anaerobically treated leachate in microbial fuel cell using Delftia acidovorans spp.