Abstract:For about 100 years, potentiometry with ion-selective electrodes has been one of the dominating electroanalytical techniques. While great advances in terms of selective chemistries and materials have been achieved in recent years, the basic manner in which ion-selective membranes are used has not fundamentally changed. The potential readings are directly co-dependent on the potential at the reference electrode, which requires maintenance and for which very few accepted alternatives have been proposed. Fouling or clogging of the exposed electrode surfaces will lead to changes in the observed potential. At the same time, the Nernst equation predicts quite small potential changes, on the order of millivolts for concentration changes on the order of a factor two, making frequent recalibration, accurate temperature control and electrode maintenance key requirements of routine analytical measurements. While the relatively advanced selective materials developed for ion-selective sensors would be highly attractive for low power remote sensing application, one should consider solutions beyond classical potentiometry to make this technology practically feasible. This paper evaluates some recent examples that may be attractive solutions to the stated problems that face potentiometric measurements. These include high-amplitude sensing approaches, with sensitivities that are an order of magnitude larger than predicted by the Nernst equation; backside calibration potentiometry, where knowledge of the magnitude of the potential is irrelevant and the system is evaluated from the backside of the membrane; controlled current coulometry with ion-selective membranes, an attractive technique for calibration-free reagent delivery without the need for standards or volumetry; localized electrochemical titrations at ion-selective membranes, making it possible to design sensors that directly monitor parameters such as total acidity for which volumetric techniques were traditionally used; and controlled potential coulometry, where all ions of interest are selectively transferred into the ion-selective organic phase, forming a calibration-free technique that would be exquisitely suitable for remote sensing applications.

Electrochemical sensors for in-situ measurement of ions in seawater

Real-Time Water Quality Monitoring with Chemical Sensors

A Miniature All-Solid-State Calcium Electrode Applied to in Situ Seawater Measurement

A Review of Nanocomposite-Modified Electrochemical Sensors for Water Quality Monitoring

A Review of Marine in Situ Sensors and Biosensors

A Novel Chemical Sensor with Multiple All-Solid-state Electrodes and Its Application in Freshwater Environmental Monitoring.

Integration of Real-Time Chemical Sensors for Deep Sea Research

A New Electroplated Ir/Ir（OH） X Ph Electrode and Its Application in the Coastal Areas of Newport Harbor, California

A Long-Term in Situ Calibration System for Chemistry Analysis of Seawater

Advances in the Technologies for Marine Salinity Measurement

Review of Underwater in Situ Voltammetry Analyzers for Trace Metals

Measuring Salinity and Density of Seawater Samples with Different Salt Compositions and Suspended Materials

Recent advances in photoelectrochemical sensors for detection of ions in water

Electrochemical Sensors and Their Applications: A Review

A Floating Capsule Electrochemical System for In Situ and Multichannel Ion-Selective Sensing

Fully Integrated, Simple, and Low-Cost Electrochemical Sensor Array for in Situ Water Quality Monitoring

Beyond potentiometry: robust electrochemical ion sensor concepts in view of remote chemical sensing

Review on In-Situ Marine Monitoring Using Physical and Chemical Optical Fiber Sensors

Feasibility investigation and development of microbial electrochemical biosensors for marine pollution monitoring

Portable Conductometric Sensing Probe for Real-Time Monitoring Ammonia Profile in Coastal Waters

Optical Voltammetry Closed-Cell Bipolar Electrochemistry Based Sensor for Portable Low-Cost Heavy Metal Water Testing