Abstract:To solve the problem of the control accuracy in electrohydraulic loading systems caused by load increment, this paper proposes a multi-cylinder electrohydraulic digital loading (MEDL) technology for accurate reproduction of large load. A traditionally used single cylinder loading (SCL) is replaced by a new hydraulic cylinders group that includes N hydraulic cylinders at each point, in which one is controlled by the electrohydraulic servo valve and the others (N-1) are controlled by the on-off valve. The areas of the on-off valve controlled (OVC) cylinders form an increasing geometric sequence with a common ratio of 2. In addition, the force of the servo valve controlled (SVC) cylinder can be regulated continuously, and the OVC cylinders have only two states of no force or maximum force. There should be no force tracking error caused by nonlinear factors for the OVC cylinders. Thus, a continuous accurate large loading can be achieved by changing the working area of the cylinders group. Moreover, an improved full closed-loop (FCL) control strategy is proposed to solve the load reverse sudden change caused by the asynchronous opening and closing of the servo valve and on-off valve. With a case of N = 4 for MEDL, AMESim simulation results illustrated that the tracking error of the 4-cylinder group was about 1/6 of the single cylinder under a case of 40 kN. Furthermore, extensive experiments conducted on a real full loading bench under the FCL control method indicated that compared with SCL, the tracking error of the 4-cylinder group with a multi-step signal and various-frequency sinusoidal signals were reduced by 73% and 46%, respectively. Both simulation and experimental results proved that the proposed MEDL technology improved the loading accuracy and optimized the dynamic performance of the system.

Load simulation test equipment, load simulation test method and control device

Loading Design for Comprehensive Performance Test Bench of Drive Axle Assembly

Measuring and Controlling System of the Accelerated Bearing Life Tester with Auto-loading

Robot leg experimental apparatus

Research and Application of Intelligent Control Method of Small Type Loader Actuator

Control method of multi-motor's speed synchronization control in dynamometer test bench for multi-axles'vehicle

Research on the Modeling, Control, and Calibration Technology of a Tracked Vehicle Load Simulation Test Bench

Research on performance test and control system for driving axle

Loading System and Control Strategy for Simulating Wind Turbine Loads

Development of Engine Connecting Rod Tension and Compression Fatigue Simulation Test Rig

The Test Device of Three-channel Electric Direct Drive Control System Simulating Automobile Steering System Parts

Control nodes based loading method: A versatile approach for multi‐degree‐of‐freedom loading in quasi‐static tests and hybrid simulations

Multi-cylinder electrohydraulic digital loading technology for reproduction of large load

Development of Load System for High-Speed Railway Rolling

Force Loading Research on the Transfixion of High-Speed Train

Development of a Novel Load Equipment for Simulated Theperformance of Propeller

Design of A Rudder Actuator Electric Loading Test System

Enhancing Electro-Hydraulic Load Simulator Performance Through Variable Arm Length and Particle Swarm-Optimized Controllers

Comprehensive test system for characteristics of rotors of four-rotor aircrafts

Design and Development of High-Performance Sliding Electrical Contact Testing Instrument

Multifunctional In-Situ Testing Device for Investigating the Service Performance of Materials