The Test Device of Three-channel Electric Direct Drive Control System Simulating Automobile Steering System Parts

Zi-chen Gao,Zhong-hua Su,Li-chang Fan
DOI: https://doi.org/10.1088/1742-6596/1965/1/012135
2021-07-01
Journal of Physics: Conference Series
Abstract:Abstract This paper briefly describes the detection status and existing problems of the current durability test of automobile parts, and designs a set of detection equipment for some parts with more accurate and complex stress structure, mainly through the combination of mechanical structure design driven by servo motor and electronic measurement and control part, so as to realize the mutual cooperative action of three channels including one linear load and two rotating loads. In the fatigue test of the steering system pull rod ball joint assembly and other parts, through the comparative test and uncertainty analysis, it is found that the uncertainty of the single actuating direction of the equipment is 82% lower than that of the traditional hydraulic cylinder actuator. At the same time, the working principle of the equipment determines that its detection energy consumption cost is far lower than that of the traditional hydraulic cylinder actuator.
What problem does this paper attempt to address?