Abstract:A new zirconium oxide-based media for arsenate removal from water was fabricated and evaluated in batch and continuous flow experiments. Highly porous (epsilonp approximately 0.9) nanostructured zirconium oxide spheres were fabricated by the impregnation of macroporous ion-exchange media (CalRes 2103, Calgon) with zirconium salt; the media was then ashed at T > 750 +/- 50 degrees C to remove the organic polymer resin and obtain ZrO2 spheres. The spheres generally ranged from 200 to 800 microm in diameter, and consisted of ZrO2 nanoastructures generally ranging between 20 and 100 nm. They also exhibited monoclinic and tetragonal crystalline structures, and had an isoelectric point of 5.6. Equilibrium batch experiments were conducted in 10 mM NaHCO3 buffered nanopure water at three pH values (6.4,7.3, and 8.3) with 120 microg/L As(V). Data were fit with the Freundlich isotherm equation (q(e) = Kx CE(1/n)), resulting in an intensity parameter (1/n) of approximately 0.33 and capacity parameters (K) ranging from 115 to 400 (microg As(V) g(-1) dry media)(L microg(-1))1/n. The pore diffusion coefficient and toruosity were estimated to be 6.4 x 10(-6) cm2 s(-1) and 1.3, respectively. For a packed bed adsorbent operating at a loading rate of 11.5 m3 m(-2) hr(-1) in a realistic continuous flow experiment, the external mass transport coefficient was estimated to be kf approximately 6.3 x 10(-3) cm s(-1). The pore diffusion coefficient and the external mass transport coefficient were used with the pore surface diffusion model (PSDM) to predict the arsenate breakthrough curve. A short bed adsorbent (SBA) test was conducted under the same conditions to validate the model. In this study, surface diffusion was ignored because the particles have a very high porosity. The validated model was used to predict arsenate breakthrough in a simulated full-scale system. The overall combined use of modeling, material characterization, equilibria, and kinetics tests determined the suitability of the media for arsenate treatment cheaper, easier, faster, and with less media than a long duration pilot test would have. Although the fabricated zirconium oxide spheres exhibited adsorption capacity comparable to some commercially available media such as iron based (hydr)oxides, the high cost of fabrication may render the media not feasible for wide use in commercial applications. However, the very high porosity of this media provides for improved pore diffusion and faster overall mass transport, which may be critical for applications where mass transport is the limiting factor.

Engineering Er-doped ZnO nanocrystals for As-removal: Targeting water remediation

Highly Efficient Removal of Arsenite from Water by Using Renewable Sub-5 Nm Zr-Mn Binary Oxides Confined Inside Gel-Type Ion Exchanger

Zirconia (ZrO2) Embedded in Carbon Nanowires via Electrospinning for Efficient Arsenic Removal from Water Combined with DFT Studies.

Enhanced Removal of Arsenic from Water by Using Sub-10 Nm Hydrated Zirconium Oxides Confined Inside Gel-Type Anion Exchanger.

Enhanced Arsenic Removal from Water by Hierarchically Porous CeO2–ZrO2 Nanospheres: Role of Surface- and Structure-Dependent Properties

Mesoporous zirconia nanostructures (MZN) for adsorption of As(III) and As(V) from aqueous solutions

Application of ZnO nanorods as an adsorbent material for the removal of As(III) from aqueous solution: kinetics, isotherms and thermodynamic studies

Removal Technology and Mechanism of Arsenic From Wastewater by Zeolite Imidazole Framework-8@Carbon Nanodots

Zinc oxide – mesoporous silica nanocomposite: preparation, characterisation and application in water treatment for lead, cadmium and chromium removal

Adsorptive removal of As(V) and As(III) from water by a Zr(IV)-loaded orange waste gel

Remediation of arsenic and lead with nanocrystalline zinc sulfide

Effective Technique and Mechanism for Simultaneous Adsorption of As(III/V) from Wastewater by Fe-ZIF-8@MXene

Enhanced arsenite removal from water using zirconium-ferrocene MOFs coupled with peroxymonosulfate:oxidation and multi-sites adsorption mechanism

Arsenate removal by nanostructured ZrO2 spheres

Effective adsorption and removal of industrial dye from aqueous solution using mesoporous zinc oxide nanoparticles via metal organic frame work: equilibrium, kinetics and thermodynamic studies

Synthesis and Characterization of Low-Cost Zirconium Nanocomposites as Novel Adsorbents for Arsenazo III Pollutant

Facile Synthesis of Manganese Dioxide Nanoparticles for Efficient Removal of Aqueous As(III)

Enhanced removal of As(III) and As(V) from water by a novel zirconium-chitosan modified spherical sodium alginate composite

Development of Efficient and Recyclable ZnO–CuO/g–C3N4 Nanocomposite for Enhanced Adsorption of Arsenic from Wastewater

Green Synthesis of Er-Doped ZnO Nanoparticles: An Investigation on the Methylene Blue, Eosin, and Ibuprofen Removal by Photodegradation

Synthesis and characterization of zeolite-based composites functionalized with nanoscale zero-valent iron for removing arsenic in the presence of selenium from water