Characterization and analysis of condensates and non-condensable gases from furfural residue via fast pyrolysis in a bubbling fluidized bed reactor

Yang Liu,Yongmeng Song,Chunmei Ran,Asif Ali Siyal,Zhihui Jiang,Polina Chtaeva,Zeyu Deng,Tianhao Zhang,Jie Fu,Wenya Ao,Chunbao Zhou,Xiangtong Li,Long Wang,Jianjun Dai

DOI: https://doi.org/10.1016/j.wasman.2021.02.025

IF: 8.816

2021-04-01

Waste Management

Abstract:<p>Pyrolysis of furfural residue (FR) was performed at 450–850 °C by employing a fluidized bed pyrolyzer (FBP). Addition of Kaolin and Ca-bentonite to FR considerably increased the condensate yields. The highest condensate yield (24.96 wt%) was obtained at 650 °C when Ca-bentonite was added. Fourier transform infra-red (FTIR) spectrum of pyrolysis oil (PO) indicated that catalysts promoted generation of alkene, amine, sulfate, sulfonyl chloride and oxime during pyrolysis. Gas chromatography mass spectrometry (GC–MS) demonstrated that catalysts significantly increased the content of furfural and phenol in PO and the maximum phenol content (15.36%) was achieved in PO650-3 for CaO. The quite low relative proportion (RP) of ammonia nitrogen in liquid indicated that the dominant form of nitrogen in liquid was not ammonia nitrogen. CaO had the ability to reduce H₂S release, indicating significant sulfur retention capacity. The maximum RP (99.29%) of chlorine in bio-char (BC) was observed with the addition of CaO, showing its strong chlorine retention capacity.</p>

environmental sciences,engineering, environmental

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to process furfural residue (FR) through fast pyrolysis technology and study the characteristics and composition of the condensate and non - condensable gases produced in the fluidized - bed reactor. Specifically, the paper focuses on the following aspects:

1. **Effect of temperature on product distribution**: Study the yield changes of bio - char (BC), condensate and non - condensable gases during the pyrolysis of furfural residue at different temperatures (from 450 °C to 850 °C), as well as the distribution of these products.

2. **Effect of catalysts on product yield and distribution**: Explore the effects of adding kaolin, calcium - based bentonite and calcium oxide (CaO) on the yield and distribution of pyrolysis products of furfural residue. In particular, study how these catalysts affect the yield and composition of the condensate, as well as the yield and composition of the non - condensable gases.

3. **Properties and composition of the condensate**: Analyze the changes in water content, pH value, main organic compounds and their chemical functional groups of the condensate produced under different conditions. The chemical composition of the condensate was characterized in detail using Fourier transform infrared spectroscopy (FTIR) and gas chromatography - mass spectrometry (GC - MS) techniques.

4. **Composition of non - condensable gases**: Study the variation rules of the main components (such as CO, CO₂, H₂ and CH₄) of non - condensable gases with temperature and catalyst types.

Through the above research, the paper aims to provide scientific basis and technical support for the effective utilization of furfural residue, especially the application potential in biomass energy and chemical production.