Abstract:Fused silica crucibles are commonly used in the fabrication process of solar grade silicon ingots. These crucibles are manufactured from high purity natural quartz sand and as a consequence, their properties are influenced by the presence of water and hydroxyls in the raw quartz. In this work, diffuse reflectance IR, 1H magic angle spinning NMR, and Raman spectroscopy were used to investigate the influence of thermal treatment on water and hydroxyl groups in high purity natural quartz sand. Most of the water in dry sand is present in the form of closed inclusions within the quartz grains which were detected in Raman imaging studies, even after thermally treating the samples at 600 °C. Only after heating to 900 °C did this water completely vanish, most likely as a result of rupturing of the inclusions. However, newly formed OH groups, identified as isolated and hydrogen bound OH were observed as products of the reaction between water and quartz. Similarly, liquid water was observed in NMR spectra even after treatment at 600 °C while at temperatures >900 °C, only non-interacting silanol groups were present. The comparison of the temperature dependence of the IR and NMR spectra also yields insight into the assignment of the OH stretching mode region of the IR spectrum in this system. The intensity of water related bands decreases while the intensity of OH bands first increases and then decreases with increasing temperature. The band intensity of Al-rich defects as well as the characteristic feature at 3200 cm-1 does not follow the temperature dependence of typical water peaks. It is also shown that leaching the quartz sand in HF solution helps to remove water from inclusions, likely by forming pathways for fluid flow inside the quartz grains. Milling of the samples caused formation of an additional type of hydroxyl group, possibly due to partial amorphisation of the surfaces of the quartz grains surface during the process. The results improve the basis for a knowledge-based processes development for the processing of high purity natural quartz.

Low‐temperature bubble formation in silica glass

Size-Dependent Brittle-To-Ductile Transition in Silica Glass Nanofibers

Structural evolution of water and hydroxyl groups during thermal, mechanical and chemical treatment of high purity natural quartz

Tuning the hardness and crack resistance through liquid–liquid phase separation in an aluminosilicate glass

Surface of silicate glass exposed to water

A Novel Method for Preparing Phase-Separated P2O5–Al2O3 Glass with High Young's Modulus

A study of SiO2 glass and supercooled liquid to 1950 K via high-temperature Raman spectroscopy

Formation and evolution of secondary phases and surface altered layers during borosilicate glass corrosion in pore water

Microstructure and Crystallization Behavior of Glasses in the ZrO2-ZnO-Al2O3-SiO2 System

Microstructure and crystallization behavior of glasses in the ZrO 2-ZnO-Al2O3-SiO2 system

Formation Mechanism of Bubbles in the Crack Healing Process of Fused Silica Using a CO2 Laser

Crystallization of A High-Strength Lithium Disilicate Glass-Ceramic: an Xrd and Solid-State Nmr Investigation

Glass Transitions and Critical Points in Orientationally Disordered Crystals and Structural Glassformers: "Strong" Liquids are More Interesting Than We Thought

Phase separation in mullite-composition glass

A study on the crystallization of CaO–Al2O3–SiO2 system glasses

Damages to Optical Silica Glass: Processes and Mechanisms

Study on the Mechanism of Second Phase Formation in High-Purity Fused Silica Materials for Semiconductor Application

Crystallization and Thermal Expansion Behavior of Lithium Zinc Silicate Sealing Glass

In Situ High-Temperature Crystallographic Evolution of a Nonstoichiometric Li2O·2SiO2 Glass

Fracture of silicate glasses: Micro-cavities and correlations between atomic-level properties

Hydroxylation and water-surface interaction for S-glass and silica glass using ReaxFF based molecular dynamics simulations