Abstract:A near-field electrospinning configuration has been developed to fabricate 3D structures by layer-by-layer stacking. The system or experimental setup consists of a high voltage source, a syringe pump, and the electrospinning equipment which has been designed and built. It works with Arduino Uno as a controller for adjusting the procedural parameters through OpenBuilds CONTROL software using a firmware preloaded on the Arduino Uno. The proposed experimental configuration consists of a collinear arrangement between the spinner and the sharp electrode, which move in the XY directions, keeping the same disposition; this arrangement is designed with the aim of manipulating the electric field (EF) and reducing instabilities associated with the process. The displacement speed (DS) and the distance of work adjust automatically to modify nanofiber features, which improves the flexibility of the system. In order to be efficient and set the EF profile, this was simulated using COMSOL Multiphysics® software. Nylon 6,6 polymeric fiber films have been electrospun to evaluate the efficiency of the system setup and the influence of parameters. The fiber morphology is studied by scanning electron microscopy and the chemical structure features are studied by infrared spectroscopy. Parameters such as voltage and DS are studied experimentally and analyzed to determine their effects on the control of fiber deposition. Stacking of up to 15 layers was obtained where the structural characteristics notably depend on the operating parameters.

Electrospinning of aligned fibers with adjustable orientation using auxiliary electrodes

Impact of Substrate Geometry on Electrospun Fiber Deposition and Alignment

Enhanced electrospinning: Multi-level fiber alignment by control of electrohydrodynamic jet motion for tissue engineering

A Step Forward in Tissue Engineering Design: Control on Multi-Scale Fiber Alignment by Electrospinning

Electro-spinning of highly-aligned polyacrylonitrile nano-fibres with continuous spooling

A General Strategy to Electrospin Nanofibers with Ultrahigh Molecular Chain Orientation

A novel XYZ electrospinning that orients the trajectory and collimates the electrified fluid jet of polymer nanofibers by induced electric fields

Design, development, and experimental setup of near-field electrospinning with a sharp electrode: Influence of procedural parameters on the 3D nanofiber structure

Orientation of Electrospun Magnetic Nanofibers Near Conductive Areas

One- and two-dimensional electrodynamic steering of electrospun polymer nanofibers

Electrospinning for Depositing Orderly Nanofiber Patterns

Electrospinning From The Edge Of An Array Of Cascade Rotating Disks

Oriented Nanofibers by a Newly Modified Electrospinning Method

Enhanced mandrel design for electrospinning aligned fiber mats from low volatility solvents

Electrospinning Highly Aligned Long Polymer Nanofibers on Large Scale by Using a Tip Collector

Controlled Assembly of Poly(vinyl Pyrrolidone) Fibers Through an Electric-Field-assisted Electrospinning Method

Electrospinning: a fascinating method for the preparation of ultrathin fibers.

Electrospinning of Nanofibers: Reinventing the Wheel?

A Novel Approach to Prepare Uniaxially Aligned Nanofibers and Longitudinally Aligned Seamless Tubes Through Electrospinning

Direct-Write, Self-Aligned Electrospinning on Paper for Controllable Fabrication of Three-Dimensional Structures.

Effects of orthogonal rotating electric fields on electrospinning process