Abstract:The data collected in the present work extend the measured phase diagram for palladium hydride and palladium deuteride to a region that has been sparsely reported in open literature. Absorption isotherms were measured using a 2.5-g bed of palladium powder at temperatures between 130 and 393 K and pressures less than 1.3 × 10<sup>5</sup> Pa. Such low-pressure and low-temperature measurements are useful for characterizing palladium beds used for tritium pumping and storage. For tritium storage, pressures are kept below a few millibars for safety reasons. Low temperatures increase the tritium storage capacity of palladium.The measured absorption isotherms show the well-documented, two-phase behavior for this system: two solubility regions and a mixed, hydride-forming region. The isotherms show that an increased quantity of hydride is formed at lower temperatures, as marked by an increase in the hydride-forming region. This region exceeds hydrogen-to-metal ratios of 0.75 for T ≤ 273 K. Equilibrium pressures in the mixed region decrease with decreasing temperatures until a critical temperature is reached for each isotope. Below these critical temperatures, the rate of pressure decrease with decreasing temperature is significantly reduced. This change in trend suggests hydrogen isotopes are adsorbed onto the palladium surface, rather than forming a hydride. Using the equilibrium pressures recorded at temperatures between 236 and 393 K for protium and between 211 and 354 K for deuterium, the van't Hoff constants were calculated to be A = −36 ± 1 kJ/mol and B = 88 ± 3 J/K for protium and A = −32 ± 2 kJ/mol and B = 88 ± 9 J/K for deuterium. These constants agree favorably with literature in the range where the temperatures of the measured isotherms overlap.

Low-Temperature Thermodynamic Properties of Palladium Bis-hexafluoroacetylacetonate

Low-temperature Heat Capacities and Thermodynamic Properties of Mn 3 (HEDTA) 2 ·10H 2 O

Low-temperature heat capacities and thermodynamic properties of Mn<sub>3</sub>(HEDTA)<sub>2</sub>·10H<sub>2</sub>O

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

Isobaric Heat Capacity of HFC-161 in the Liquid Phase at Temperatures Up to 360.15 K and Pressures Up to 5.5 MPa

PVTx Properties in the Gas Phase for Difluoromethane (HFC-32) + Pentafluoroethane (HFC-125)

Measurement of Palladium Hydride and Palladium Deuteride Isotherms Between 130 K and 393 K

Pvtx Properties In The Gas Phase For Difluoromethane (Hfc-32) Plus Pentafluoroethane (Hfc-125)

Non-equilibrium heat capacity of polytetrafluoroethylene at room temperature

Low-Temperature Heat Capacity and Thermodynamic Properties of Crystalline 2-Chloro-5-trichloromethylpyridine

Low-Temperature Heat Capacity of Lanthanum Hafnate

Heat capacity and thermal decomposition of 1,6-bis(diphenylphosphino)hexane

Thermodynamic Properties of 3- and 4-Ethoxyacetanilides between 80 and 480 K

Palladium at high pressure and high temperature: A combined experimental and theoretical study

Thermodynamic properties and phase equilibria in the Fe–P system

Thermoelectric properties of polycrystalline palladium sulfide

Aging effects on thermodynamics in palladium–tritium system during tritium storage

The Thermodynamic Characteristics of Pd2Y-H System

Resistivity Measurements in Palladium Hydride Film Prepared by Low-Temperature Hydrogen Absorption Method

Density Functional Theory Study on the Thermodynamic Properties of Polybrominated Diphenylamines

Superconductivity in palladium hydride and deuteride at 52-61 kelvin