Abstract:The article analyzes the analytical nature of complex criteria for assessing grain production in agricultural enterprises by intensifying engineering management. Effective use of combine harvesters and the amount of grain losses during combining in agricultural producers depend on the classic set of organizational, technical, technological factors and the state of engineering and technical service. In order to increase the efficiency of machinery, it is advisable to use operational technology for harvesting cereals, which includes maps and drawings on the following issues: choice of technologies, agronomic requirements, safety, selection and assembly of units, preparation of units, field and detachment preparation, organization of work of units in detachments, transport works, norms of production and fuel consumption, control and estimation of quality of work. It was established that the average daily productivity of the combine during the first 3 years of use was 14.6-16.1 ha; seasonal - 302-314 hectares; grain threshing - 59-161 tons per day and 1280-1440 tons - per season. To obtain the required productivity and quality of threshing, it is necessary to constantly monitor the size of the gap between the drum and the drum. To increase the productivity of grain unloading, it is advisable to carry out while moving without stopping the combine, because when threshing 60 tons per day, approximately 1.6 hours of working time are lost.It was found that the existing harvesting system does not take into account the dynamics of grain and straw ripening and their purpose according to the scheme: entry into the process (first phase), the main part of the above average (second phase) and exit from the process (third phase), inefficient due to low survivability of the collection system in organizations, regions and oblasts in the first and third phases. Analysis of numerical indicators shows that when all crops are harvested, the pace of the process in the first phase increases slowly, in the second - faster, and at the output decreases to a minimum. In the first phase, the average rate for rye, barley, oats and wheat reaches 0.25, respectively; 0.21; 0.30 and 0.26 cycle times. The duration of harvesting each crop with a rate above average is less than half the duration of the cycle, and with a rate below average - more than half. The general conclusion from the given data comes down to the fact that 26-33% of the harvest in farms can be obtained by using resource-saving technologies. Analysis and synthesis of the regularity of the harvesting process shows that during one day the maximum rate reached 18.2-34.9% of the total, which exceeded the average rate by 3.58 times.

The experimental research of combine harvesters

RESEARCH ON THE INFLUENCE OF THE OPERATING MODES OF COMBINE HARVESTER’S TRANSPORTATION LINES ON THE QUALITY OF GRAIN THRESHING

Results of Industrial Application of a Combine Harvester When Unloading Grain at the Edge of the Field

Comparative Experiment on the Use of Unmanned and Ground-Based Technologies of Fertilizer and Crop Protection Products on Winter Barley

Increase in grain combine harvester performance and in quality of harvesting grain crops

Wheat harvesting by combine with GPS receiver and grain sensor

Determination of operation performance indicators of unit for mowing crops with the simultaneous incorporation of their stubble into the soil

The effect of agronomic measures on grain yield of winter wheat in drier conditions

Experimental Studies of the Seed-Sowing Device for the Grain Seeder SUBM-3.6

Structure Design and Performance Test of Wheat Combine Harvester Based on Numerical Modeling

DESIGN AND FIELD TEST OF A NEW COMPACT SELF-PROPELLED CABBAGE HARVESTER

Analyticity of complex criteria for evaluation of grain production in agricultural enterprises intensification of engineering management

Experiment and Parameter Optimization of an Automatic Row Following System for the Traction Beet Combine Harvester

Change of Technical Condition and Productivity of Grain Harvesters Depending on Term of Operation

On the rational choice of a combine harvester and a reaper for grain harvesting in conditions of Siberia

Comparative evaluation of seeding spring wheat methods when using different types of coulters

Development of a methodology for choosing conditions of interaction between harvesting and transport complexes

Single-Pass, Single-Stream Harvest of Corn Grain and Stover: a Comparison of Two Harvest Methods

EVALUATION OF ENERGY INDICATORS OF GRUNDING AGGREGATE

Results of laboratory and field tests of the deep-loosening process with the RVN-3 subsoiler

Design and Test of a Grain Cleaning Loss Monitoring Device for Wheat Combine Harvester