Abstract:The ever-increasing silicon photovoltaics industry produces a huge annual production of silicon waste (2.03 × 105 tons in 2019), while lignin is one of the main waste materials in the traditional paper industry (7.0 × 107 tons annually), which lead to not only enormous wastage of resources but also serious environment pollution. Lithium-ion batteries (LIBs) are the dominating power sources for portable electronics and electric vehicles. Silicon (Si)-based material is the most promising anode choice for the next-generation high-energy-density LIBs due to its much higher capacity than the commercial graphite anode. Here, we proposed the use of these silicon and lignin waste as sustainable raw materials to fabricate high-capacity silicon/carbon (Si/C) anode materials for LIBs via a facile coprecipitation method utilizing electrostatic attracting force, followed by a thermal annealing process. The as-achieved Si/C composite featured an advanced material structure with micrometer-sized secondary particles and Si nanoparticles embedded in the carbon matrix, which could tackle the inherent challenges of Si materials, including low conductivity and large volume change during the lithiation/delithiation processes. As expected, the obtained Si/C composite displayed an initial charge capacity of 1016.8 mAh g–1, which was 3 times that of a commercial graphite anode in the state-of-the-art LIBs, as well as a high capacity retention of 74.5% at 0.2 A g–1 after 100 cycles. In addition, this Si/C composite delivered superior rate capability with a high capacity of 575.9 mAh g–1 at 2 A g–1, 63.4% of the capacity at 0.2 A g–1. The utilization of industrial Si and lignin waste provides a sustainable route for the fabrication of advanced high-capacity anode materials for the next-generation LIBs with high economic and environmental feasibility.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.0c16865?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.0c16865</a>.Additional experimental data including SEM, TEM, and HR-TEM images of Si–C and Si/C composite after cycles and EIS spectra of Si/C and pure Si before cycling (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c16865/suppl_file/am0c16865_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Trash to Treasure: Harmful Fly Ash Derived Silicon Nanoparticles for Enhanced Lithium-Ion Batteries

Scalable and Low-Cost Synthesis of Porous Silicon Nanoparticles As High-Performance Lithium-Ion Battery Anode

In Situ Formation of Ionically Conductive Nanointerphase on Si Particles for Stable Battery Anode

Industrial waste micron-sized silicon use for Si@C microspheres anodes in low-cost lithium-ion batteries

Porous silicon from industrial waste engineered for superior stability lithium-ion battery anodes

Rational design of fly ash-based composites for sustainable lithium-ion battery anodes

Facile Fabrication of High-Performance Li-Ion Battery Carbonaceous Anode from Li-Ion Battery Waste

High-Value Utilization of Silicon Cutting Waste and Excrementum Bombycis to Synthesize Silicon–Carbon Composites as Anode Materials for Li-Ion Batteries

Si-based composite deriving from wok ash waste as high-performance anode for Li-ion battery

Recycling of Lignin and Si Waste for Advanced Si/C Battery Anodes

Recycling silicon-based industrial waste as sustainable sources of Si/SiO2 composites for high-performance Li-ion battery anodes

Preparation of WSi@SiOx/Ti3C2 from photovoltaic silicon waste as high-performance anode materials for lithium-ion batteries

Stirring-enabled formation of homogenous sub-50 nm silicon nanoparticles with a modified alumino-reduction of silica as high-performance anode materials

Surface Modification of Silicon Nanoparticles by an "Ink" Layer for Advanced Lithium Ion Batteries.

Constructing triple-protected Si/SiOx@ZnO@C anode derived from volatile silicon waste for enhanced lithium storage capacity

Low-cost and Scalable Preparation of Nano-Si from Photovoltaic Waste Silicon for High-Performance Li-ion Battery Anode

Recycling Silicon Waste from the Photovoltaic Industry to Prepare Yolk–Shell Si@void@C Anode Materials for Lithium–Ion Batteries

Pyromellitic Acid Induced Stable Lithium Ion Batteries Based on Recycled Silicon Flakes

Construction of P-Sinps/Ag@C Composites by Silver-Assisted Etching Residual Silicon Waste Toward Anode Material for Lithium-Ion Battery

A self-driven alloying/dealloying approach to nanostructuring micro-silicon for high-performance lithium-ion battery anodes

Millisecond Conversion of Photovoltaic Silicon Waste to Binder‐Free High Silicon Content Nanowires Electrodes