Abstract:Introduction. The control algorithm of Induction Motor (IM) is massively dependent on its parameters; so, any variation in these parameters (especially in rotor resistance) gives unavoidably error propagates. To avoid this problem, researches give more than solution, they have proposed Variable Structure Control (VSC), adaptive observers such as Model Reference Adaptive System, Extended Luenberger Observer (ELO) and the Extended Kalman Filter (EKF), these solutions reduce the estimated errors in flux and speed. As novelty in this paper, the model speed observer uses the estimated currents and voltages as state variables; we develop this one by an error feedback corrector. The Indirect Rotor Field Oriented Control (IRFOC) uses the correct observed value of speed; in our research, we improve the observer’s labour by using back-stepping Sliding Mode (SM) control. Purpose. To generate the pulse-width modulation inverter pulses which reduce the error due of parameters variations in very fast way. Methods. We develop for reach this goal an exploration of two different linear observers used for a high performance VSC IM drive that is robust against speed and load torque variations. Firstly, we present a three levels inverter chosen to supply the IM; we present its modelling and method of control, ending by an experiment platform to show its output signal. A block diagram of IRFOC was presented; we analyse with mathematic equations the deferent stages of modelling, showed clearly the decoupling theory and the sensorless technique of control. The study described two kinds of observers, ELO and EKF, to estimate IM speed and torque. By the next of that, we optimize the step response using the fuzzy logic, which helps the system to generate the PI controller gains. Both of the two observers are forward by SM current controller, the convergence of SM-ELO and SM-EKF structures is guaranteed by minimizing the error between actual and observed currents to zero. Results. Several results are given to show the effectiveness of proposed schemes.

Non-linear backstepping control of five-phase IM drive at low speed conditions-experimental implementation

Speed Sensorless Nonlinear Control Of Pmsm Drives

A New Reactive Power-Based Sensorless Control Strategy For Five-Phase Induction Motor With Non-Sinusoidal Power Supply

Nonlinear Speed Sensorless Control Of Pmsm Drives

A novel fault tolerant control approach based on backstepping controller for a five phase induction motor drive: Experimental investigation

Backstepping Control of Speed for Sensorless Permanent Magnet Synchronous Motor

SPEED TRACKING CONTROL OF PERMANENT MAGNET SYNCHRONOUS MOTOR WITH BACKSTEPPING

DSP-based adaptive backstepping using the tracking errors for high-performance sensorless speed control of induction motor drive

An Enhanced Sliding Mode Speed Control for Induction Motor Drives

Research of V/f Control Method for Multiphase Induction Motor with Non-sinusoidal Supply at Low Speed

Nonlinear Speed Control for Five-Phase PMSM in Electric Vehicles

A Non-Integer High-Order Sliding Mode Control of Induction Motor with Machine Learning-Based Speed Observer

Hybrid Backstepping-Super Twisting Algorithm for Robust Speed Control of a Three-Phase Induction Motor

Adaptive control schemes for improving dynamic performance of efficiency-optimized induction motor drives

An Efficient Control of A Series Connected Two-Synchronous Motor 5-Phase with Non Sinusoidal Emf Supplied by A Single 5-Leg Vsi: Experimental and Theoretical Investigations

Intelligent fuzzy back-stepping observer design based induction motor robust nonlinear sensorless control

Low-Speed Performance Improvement of Direct Torque Control for Induction Motor Drives Fed by Three-Level NPC Inverter

Modeling, Control, and Experimental Investigation of a Five-Phase Series-Connected Two-Motor Drive With Single Inverter Supply

Adaptive Backstepping Integral Sliding Mode Control of a MIMO Separately Excited DC Motor

Adaptive Passivity-Based Control Of Induction Motors Without Speed Sensors