NUMERICAL CALCULATION OF THE CHANGE OF GEOMETRY OF THE WHEEL OF THE SPIRAL-CONICAL REDUCER AT HEAT TREATMENT

Elena Kuznetsova,Natalya Podkina,,

DOI: https://doi.org/10.15593/2499-9873/2019.1.03

2019-03-30

Applied Mathematics and Control Sciences

Abstract:In work simulation of heat treatment of krivozuby conic transfer of an intermediate reducer of the helicopter in the Deform-3D and ANSYS programs is carried out, methods of the prevention of change of the geometrical sizes of a detail in the course of heat treatment are offered. It in turn will allow to improve maintainability indicators. In the conditions of the raised loading, responsibility, military operations of Mi-28H has to "survive" and normally function in various conditions of environment, at influence of the strong destroying factors, such as an overload, high speed, shock loadings, vibration, etc. In this regard reducers too should work in the conditions of high loadings. Purpose of the main reducer is a distribution of power between helicopter mechanisms which is transferred by engines. Also, the main reducer is necessary to provide the draft force sufficient for the flight modes. Thus consumes the main share of power bearing the screw which is installed on a shaft of the main reducer. Management of a step and rotation of the steering screw is carried out by a tail reducer at which the transfer relation as well as an intermediate reducer small, and transfer is carried out at an angle 90°. Taking into account all parameters the major and topical questions in branch of helicopter engineering which decision will allow to increase reliability and durability, to reduce metallosses and to increase profitability of production at production of details are considered.