Research on Laser Online Monitoring Equipment for High-Temperature Corrosive Gas in Coal-Fired Boilers
Long Li,Shuai Shi,Ting Gong,Ya-li Tian,Gu-qing Guo,Xuan-bing Qiu,Xiao-he Xiong,Chuan-liang Li
DOI: https://doi.org/10.37188/co.2023-0209
IF: 1.1
2024-01-01
Chinese Optics
Abstract:The coal-fired boiler combustion process's economic, safety, and environmental performance holds great significance when constructing smart power plants. In coal-fired boiler combustion,H2S and CO are the two main high-temperature corrosive gases. They not only corrode the boiler near the wall surface but also pose severe harm to the atmospheric environment through their exhaust gases. Based on the near-infrared tunable diode laser absorption spectroscopy technology, combined with wavelength modulation spectroscopy and frequency division multiplexing technology, an unstaffed online real-time monitoring instrument for H2S and CO gas concentrations in the main combustion zone of coal-fired boilers was developed. Gas absorption spectroscopy in the 6 335 similar to 6 341 cm(-1) range was simulated, and two near-infrared lasers near 1.5 mu m were selected as the laser source. A high-temperature resistant and corrosion-resistant Herriott-type multi- pass cell was developed to attain an effective optical path length of 15 m for the interaction between laser and gas. Hardware circuits and corresponding firmware programs were developed to attain secondary demodulation of the absorption spectroscopy signals of H2S and CO and concentration inversion. The linearity and Allan variance experiments showed linear fitting correlation coefficients of 0.999 8 and 0.9995. At 73 s and 53 s integration times, the minimum detection limits for H2S and CO were 0.2x10(-6) mol/mol and 0.344x10(-6) mol/mol, respectively. Finally, the developed instrument was applied in the combustion atmosphere of the main combustion zone of a 300 MW tangential four-corner coal-fired boiler, and synchronous measurements of H2S and CO near the water-cooled wall were conducted. The results indicated a positive correlation between the concentrations of H2S and CO in the boiler, with anaerobic combustion leading to an increase in the content of these gases and causing corrosion to the water-cooled wall.