Abstract:— The possible formation of a solid phase in the lead coolant in the BREST-OD-300 reactor, a problem common for reactors of such type, is numerically investigated. For modeling unsteady processes in the steam generator operating with a liquid-metal coolant under the conditions involving the occurrence of crystallization–melting phenomena, a procedure that makes it possible to take into account the process ambiguity depending on the state of the heat-transfer contact surface oxide layer was used. Accidents caused by a rupture of the main steam header and by failure of the regenerative feedwater heating system are considered. The influence of certain reactor parameters on the solid phase formation dynamics in such accidents is estimated. If loss of tightness occurs in the main steam header with simultaneous loss of power supply to the reactor and failure of the steam generators' shutoff and control valves and also in the case of regenerative feedwater heating system failure with retaining the supply of feedwater to the steam generators, the solid phase fully blocks the flow section in all four loops of the primary coolant circuit. Depending on the state of the heat-transfer contact surface oxide layer, the flow sections of the steam generators themselves or those of the steam generator cavities in the concrete shell can be blocked. The main factor causing the lead coolant to become solidified in the case of steam header rupture is a sufficiently large amount of feedwater in the secondary coolant circuit pipelines and heat-transfer equipment at high pressure. At the same time, in an accident involving failure of the regenerative feedwater heating system, this volume is not of key importance for the solid phase formation dynamics in the lead coolant. The study results can be used in elaborating the designs of lead cooled reactors.

Fragmentation and solidification of fuel–coolant interaction of columnar molten iron and water

Steam cavity and explosion intensity of molten copper column interaction with water

Wetting and Spreading Behavior of Molten Iron in Contact with Graphite Substrate: Interfacial Effects

Study of the effect of seawater properties on the performance of molten fuel fragmentation

A mechanism for spontaneous thermal fragmentation with coolant entrainment during the molten fuel–sodium interaction

Numerical Investigation of Melt Fragmentation in Sodium-Cooled Fast Reactor Based on Moving Particle Method

Experimental investigation on the characteristics of molten lead–bismuth non-eutectic alloy fragmentation in water

Influence of Interface Electric Field on Interaction Between Molten Iron and Refractory Interface

Effect of water vapour on the interface reaction between carbon brick and molten iron in blast furnace hearth

Numerical Simulation of the Interaction Between Supersonic Oxygen Jets and Molten Slag–Metal Bath in Steelmaking BOF Process

Analysis of internal energy and mass loss rate of fuel with water sublayer at different initial temperatures

Experimental study on fragmentation characteristics of molten stainless steel discharged into liquid Lead-Bismuth Eutectic pool

Experimental study on the plate-type fuel melting behavior based on alternative materials

Numerical simulation of solidification of boiler molten ash impinging on vertical wall based on Smoothed Particle Hydrodynamics method

Numerical Investigation of a Class of Accidents in the Generation IV Brest Reactor Involving the Formation of a Solid Phase in the Lead Coolant

Heat transfer of film boiling on the molten metal after water injection

Experimental study on thermal-hydraulic behaviour of LBE and water interface

Dynamic interaction of refractory and molten steel: Corrosion mechanism of alumina-magnesia castables

An Experimental Study on Steam Explosion of a Small Melt Jet Falling into a Water Pool

Numerical investigations on the component separation phenomenon and transport behavior of steam-air-hydrogen mixture induced by condensation

Comparison of Two Different Fuel-Coolant Interaction Systems