Abstract:Mathematics and Mechanics of Solids, Ahead of Print. A new non-classical model for spatial rods incorporating surface energy effects is developed using a surface elasticity theory. A variational formulation based on the principle of minimum total potential energy is employed, which leads to the simultaneous determination of the equilibrium equations and complete boundary conditions. The newly developed spatial rod model contains three surface elasticity constants to account for surface energy effects. The new model recovers the classical elasticity-based Kirchhoff rod model as a special case when the surface energy effects are not considered. To illustrate the new spatial rod model, two sample problems are analytically solved by directly applying the general formulas derived. The first one is the buckling of an elastic rod of circular cross-section with fixed-pinned supports, and the other is the equilibrium analysis of a helical rod deformed from a straight rod. An analytical formula is derived for the critical buckling load required to perturb the axially compressed straight rod, and two closed-form expressions are obtained for the force and couple needed in deforming the helical rod. These formulas reduce to those based on classical elasticity when the surface energy effects are suppressed. For the buckling problem, it is found that the critical buckling load predicted by the current new model is always higher than that given by the classical elasticity-based model, and the difference between the two sets of predicted values is significantly large when the radius of the rod is sufficiently small but diminishes as the rod radius increases. For the helical rod problem, the numerical results reveal that the force and couple predicted by the current model are, respectively, significantly larger and smaller than those predicted by the classical model when the rod radius is very small, but the difference is diminishing with the increase of the rod radius.

Equilibrium analysis of surface-constrained elastic rods: Unveiling contact and internal forces through local geometry

Relation between the contact force and local geometry for an elastic curve under general surface confinement

A new model for spatial rods incorporating surface energy effects

On a consistent rod theory for a linearized anisotropic elastic material II. Verification and parametric study

On a consistent rod theory for a linearized anisotropic elastic material: I. Asymptotic reduction method

Elastic solids under frictionless rigid contact and configurational force

Transverse Surface Mechanical Behavior and Modified Elastic Modulus for Charged Nanostructures

Partial Constraint Singularities in Elastic Rods

Geometrically Exact Simulation of Inextensible Ribbon

An isogeometric finite element formulation for frictionless contact of Cosserat rods with unconstrained directors

Energy-minimizing configurations for an elastic rod with self-contact energy close to the inextensible–unshearable and hard-contact limits

On the Elastic Rod Models for Mechanical Tests of One-Dimensional Nanostructures under Transverse Loads

New effective bending rigidity and structural instability analysis of noncircular cross-section elastic rod model

Analysis and Convenient Formulas for Elasto-Plastic Contacts of Nominally Flat Surfaces: Average Gap, Contact Area Ratio, and Plastically Deformed Volume

Conformal Deformations of a Dilational Material Surface

A quaternion-based continuation method to follow the equilibria and stability of slender elastic rods

On self-contact and non-interpenetration of elastic rods

Planar equilibria of an elastic rod wrapped around a circular capstan

On the theory of rods. I. Derivations from the three-dimensional equations

Buckling of a Slender Rod Confined in a Circular Tube: Theory, Simulation, and Experiment

Post-Buckling Analysis of a Rod Confined in a Cylindrical Tube