Planar equilibria of an elastic rod wrapped around a circular capstan

Harmeet Singh

DOI: https://doi.org/10.1007/s10659-022-09939-8

2022-10-15

Abstract:We present a study on planar equilibria of a terminally loaded elastic rod wrapped around a rigid circular capstan. Both frictionless and frictional contact between the rod and the capstan are considered. We identify three cases of frictionless contact -- namely where the rod touches the capstan at one point, along a continuous arc, and at two points. We show that, in contrast to a fully flexible filament, an elastic rod of \emph{finite length} wrapped around a capstan does not require friction to support unequal loads at its two ends. Furthermore, we classify rod equilibria corresponding to the three aforementioned cases in a limit where the length of the rod is much larger than the radius of the capstan. In the same limit, we incorporate frictional interaction between the rod and the capstan, and compute limiting equilibria of the rod. Our solution to the frictional case fully generalizes the \emph{classic capstan problem} to include the effects of finite thickness and bending elasticity of a flexible filament wrapped around a circular capstan.

Soft Condensed Matter,Mathematical Physics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is the planar equilibrium problem of elastic filaments in the classical reel problem when they are wrapped around a circular reel. Specifically, the author generalizes the classical reel problem by regarding the filament as an elastic rod with a finite thickness and studies the frictionless and frictional contact situations between this elastic rod and the reel. The main objectives are:

1. **Consider bending elasticity**: Unlike in the classical reel problem where the bending elasticity of the filament is ignored, this paper takes into account the bending elasticity of the filament. This causes the filament to bend outward at the contact boundaries (i.e., points \( s_1 \) and \( s_2 \) in Figure 1b), thus complicating the calculation of the contact angle \( \phi_c \).

2. **Determine the contact boundaries**: In this paper, the two ends of the contact area (i.e., points \( s_1 \) and \( s_2 \) in Figure 1b) are regarded as free boundaries. The exact positions of these boundaries cannot be pre - specified but must be determined as part of the solution.

3. **Introduce jump conditions**: The author systematically derives a jump condition through the principle of virtual work. This condition is used not only to determine the positions of the contact boundaries on the centerline of the elastic rod but also to determine the jumps of internal forces and curvatures at these points.

4. **Analyze the frictionless contact situation**: In the frictionless contact situation, the author calculates three different equilibrium states of the elastic rod, namely, the elastic rod contacts the reel at one point, a continuous arc segment, or two points. The research shows that an elastic rod of finite length can support unequal loads at both ends even without friction, which is achieved through its bending elasticity, in sharp contrast to the situation in the classical reel problem where the loads at both ends are equal in the frictionless case.

5. **Consider the influence of friction**: Under the same limiting conditions (i.e., the length of the elastic rod is much greater than the radius of the reel), the author also considers the frictional action between the reel and the elastic rod and generalizes the classical reel equation. The results show that the maximum force ratio \( \frac{F_L}{F_0} \) depends not only on the winding angle \( \phi \) but also on the input load \( F_0 \).

In conclusion, this paper aims to more comprehensively understand and describe the mechanical behavior in the reel problem by considering the bending elasticity of elastic filaments, thereby providing a more accurate theoretical basis for engineering design.