Abstract:Thin film technology has emerged as a cornerstone in optoelectronics, enabling the fabrication of compact, lightweight devices with enhanced performance and efficiency through precise control of the nanoscale thicknesses of functional materials. The current study explores the impact of copper (Cu) doping (3.125%, 6.25%, and 12.5%) on lead (Pb) sites in PbS to examine the structural, morphological, electronic, optical, and thermoelectric characteristics, employing both experimental and theoretical approaches. Polycrystalline thin films of PbS are deposited by spin coating technique on glass substrates. The XRD study discloses the cubic crystal structure of pristine and Cu-doped PbS with nominal variation in d-spacing. Surface morphological investigations reveal that Cu-doping transforms the coffee beans like grains to nanoplates that significantly affect the surface homogeneity and porosity. The tuning of band structure in the visible range, 1.64-2.21 eV is witnessed in the band structure analysis. Moreover, the experimental results are complemented by a theoretical study using WIEN2k software. Theoretical study exhibits the direct bandgap nature and with the incorporation of Cu, it increases from 0.89 to 2.11 eV. The density of states spectra for Cu-doped PbS exhibits strong hybridization between p-states of Pb and S, and d-states of Cu. Optical findings demonstrate significant variations in the absorption spectrum, which result in modifications in the optical energy band gap and peculiar optical parameters of doped samples. At room temperature, the increase in electrical conductivity from 0.2x1020 (Ω.m.s)-1 for PbS to 0.3x1020, 3.1x1020 and 7.8 x1020 (Ω.m.s)-1¬¬, thermal conductivity from 0.25x1014 W/m.K.s to 0.30x1014, 2.4x1014 and 5.2x1014 W/m.K.s and decrease in Seebeck coefficient from 72 to 35, 13 and 8 μV/K with the inclusion of Cu up to 3.125, 6.25 and 12.5% offer the potential for advancing thermoelectric technology. This could lead to improved efficiency and practical utilization in energy harvesting and waste heat recovery.

Electro-optical characterization of rare earth doped CuInS2 thin films synthesized by CBD

Studies of Undoped and Doped Films of CuInS2

Fabrication and characterization of CuInS 2 films by chemical bath deposition in acid conditions

Influence of Ce Doping on Structural and Photoelectric Properties of CuInS2 Thin Films

Surface characterization of Cu-doped indium sulfide thin films

EFFECT OF INDIUM DOPING ON STRUCTURAL, OPTICAL AND ELECTRICAL PROPERTIES OF CADMIUM SULFIDE THIN FILMS

Research on CuInS2 Thin Films Prepared by One-step Electrodeposition

Investigation of structural, morphological, optical and electronic properties of Cu-doped PbS thin films: a comparative experimental and theoretical study

Improvement of the photoelectrical properties of chemical bath-deposited Sb2S3 thin films with low copper doping

Effect of Heat Treatment on the Property of Cuins2 Thin Film Prepared by Chemical Bath Deposition

Structural And Photoelectrochemical Properties Of Cu-Doped Cds Thin Films Prepared By Ultrasonic Spray Pyrolysis

Electrochemical deposition of Cr3+ doped CuInSe2 thin films for electrocatalytic activity and photovoltaic performance

Structural, optical, and electrical properties of indium-doped cadmium oxide films prepared by pulsed filtered cathodic arc deposition

Structural, Optical, and Electrical Properties of Cu-Doped ZnS Nanoparticles Prepared by Solid-State Reaction

Optical Transmission, Photoconductivity, and Morphology of Chemical Bath-Deposited CdS Thin Films for Optoelectronic Applications

Synthesis and Characterization of Ce-Incorporated Cuins2 Chalcopyrites

Photo-sensing properties of Cd-doped In2S3 thin films fabricated via low-cost nebulizer spray pyrolysis technique

Effect of Substrate and Zn Doping on the Structural, Optical and Electrical Properties of Cds Thin Films Prepared by Cbd Method

Optical absorption studies on polycrystalline Cu0.5Ag0.5InSe2 thin films

Impact of europium (III) on optoelectronic properties of CZTS thin films prepared by spin coating method

Sb-doping effects on optical and electrical parameters of SnO2 films