Abstract:In southern power grid, four 500kV composite wall bushings used at a converter station was found significantly aging after 15 years' operation, such as chalking, cracks and low hydrophobicity. The housing material of these wall bushings is liquid silicone rubber (LSR). In order to extend the service life, the out door insulation was repaired by RTV. As the internal failure, one of the four bushings was forced to be out of service. In this paper, the outer shed of the wall bushing was used to evaluate the aging characteristics of the LSR sheds after long term operation. The macroscopic aging characteristics of LSR sheds were investigated by using hydrophobicity and hydrophobicity transfer test, tensile and tear strength test. The microscopic characteristics of the aging sheds were obtained by using Scanning Electron Microsope (SEM), Fourier Transform Infrared Spectroscopy (FTIR) and X-ray Photoelectron Spectroscopy (XPS). It was found that the aging of the LSR shed developed from outer surface into the inside, and the layer structure including the chalking layer and the inner layer was obviously observed. The hydrophobicity, hydrophobicity transfer, tensile strength and tear strength of the aging sheds had different decrease. At microcosmic angle of view, the aging sheds appeared irregular shaped patches with a reduced surface roughness and adhesion; FTIR and XPS results indicated that the side chain groups of PDMS in the chalking layer were oxidized, crosslinked with other polysiloxane chains, forming more Si-O-Si groups, accompanied by the precipitation of TiO2 and white carbon black fillers. Due to the change of silicone rubber material from organic to inorganic, the content of C and Si elements in the chalking layer decreased, and the content of O element increased.The research also shows that, the hydrophobicity and hydrophobicity transfer of the aging LSR sheds can be improved by RTV repairment, but the appearance and hydrophobic changes still needs to be regularly monitored in the operation.

The effect of aging during storage on the performance of a radial lip seal

The effect of aging in oil on the performance of a radial lip seal

The Change of Sealing Property in the Aging Process of NBR Sealing Equipment Based on Finite Element Analysis

Macroscopical contact pressure and microscopic leakage performance analysis of rubber seal considering thermal oxygen aging effect

Research on the Aging Effects of Adhesive and Composites on the Degradation Mechanism of Composite Adhesive Joints in Thermal-Humidity-Cycles for Automobiles

Multiscale simulation on dynamic friction behavior of cylinder sealing rings under hydrothermal aging

Study on the aging of three typical rubber materials under high- and low-temperature cyclic environment

Accelerated Aging Test and Study of Storage Life Prediction of NBR O-Ring

The Influence of Oil and Thermal Aging on the Sealing Characteristics of NBR Seals

Experimental Investigations on the Dynamic Mechanical Properties of Aged Rubbers

Prediction for O-Ring Type Sealing Ring's Storage Life Based on Accelerated Ageing Data

Experimental study on mechanical property degradation of thermal aging laminated rubber bearing

The Effect of Wear on the Performance of a Rotary Lip Seal

Synergistic Effects of Multiple Environmental Factors on Degradation of Silicone Rubber Seals under Marine Atmosphere

Research status and prospect of wear and aging on hydraulic rubber sealing materials

Mechanical, Thermal, and Morphological Behavior of Silicone Rubber during Accelerated Aging

Numerical Simulation Study on Battery-Casing Sealing Considering Rubber Aging

Long-term sealing performance evaluation and service life prediction of O-rings under thermal-mechanical coupling conditions

The Deterioration of Foamed Silicone Rubber in Humid and Hot Environments

Aging Characteristics and Repairing Evaluation of Long-term Operating LSR Bushings

Correlations between the Aging Behavior and Finite Element Method Simulation of Three Silicone Elastomers