Abstract:Unmanned Aerial Vehicles (UAVs) have slowly but steadily emerged as a research and commercial hotspot because of their widespread applications. Due to their agility, compact size, and ability to integrate multiple sensors, they are mostly sought for applications that require supplementing human effort in risky and monotonous missions. Despite all of these advantages, rotorcrafts, in general, are limited by their endurance and power-intensive flight requirements, which consequently affect the time of flight and operational range. On the other hand, fixed-wing aircrafts have an extended range, as the entire thrust force is along the direction of motion and are inherently more stable but are limited by their takeoff and landing strip requirements. One of the potential solutions to increase the endurance of VTOL rotorcrafts (Vertical Take-Off and Landing Vehicles) was to exploit the thrust vectoring ability of the individual actuators in multi-rotors, which would enable take-off and hovering as a VTOL vehicle and flight as a fixed-wing aircraft. The primary aim of this paper is to lay out the overall design process of a Hybrid VTOL tilt-rotor UAV from the initial conceptual sketch to the final fabricated prototype. The novelty of the design lies in achieving thrust vectoring capabilities in a fixed-wing platform with minimum actuation and no additional control complexity. This paper presents novel bi-copter that has been designed to perform as a hybrid configuration in both VTOL and fixed wing conditions with minimum actuators in comparison to existing designs. The unified dynamic modelling along with the approximation of multiple aerodynamic coefficients by numerical simulations is also presented. The overall conceptual design, dynamic modeling, computational simulation, and experimental analysis of the novel hybrid fixed-wing bi-copter with thrust vectoring capabilities aiming to substantially increase the flight range and endurance compared to the conventional aircraft rotorcraft configurations are presented.

TactV: A Class of Hybrid Terrestrial/Aerial Coaxial Tilt-Rotor Vehicles

A Minimal Thrust Vectoring Rotor with Six Degree of Freedom: Design and Analysis

TIE: an Autonomous and Adaptive Terrestrial-Aerial Quadrotor

Automated Design Optimization of a Mono Tiltrotor in Hovering and Cruising States

Structure Design and Control of a Novel Tilt-rotor Quadrotor with Thrust Vectoring

Design and Control of a Novel Coaxial Tilt-Rotor UAV

Coaxial Tilt-Rotor UAV: Fixed-time Control, Mixer, and Flight Test

Dynamics Analysis and Control of Coaxial High-Speed Helicopter in Transition Flight

Large-Sized Multirotor Design: Accurate Modeling with Aerodynamics and Optimization for Rotor Tilt Angle

6-DOF All-Terrain Cyclocopter

Rotor Cross-Tilt Optimization of Manned Multi-rotor Evtol Aircraft for Yaw Control Efficiency

Tiltrotor Conversion System Design and Flight Dynamics Simulation for VTOL Aircraft

Control and Flight Test of A Tilt-Rotor Unmanned Aerial Vehicle

Design, Analysis, and Testing of a Hybrid VTOL Tilt-Rotor UAV for Increased Endurance

Roller-Quadrotor: A Novel Hybrid Terrestrial/Aerial Quadrotor with Unicycle-Driven and Rotor-Assisted Turning

Design, Modeling, and Control of a Coaxial Drone

Aerodynamic structural design and control for a new miniature coaxial dual-rotor unmanned aerial vehicle

Modeling and control of lift offset coaxial and tiltrotor rotorcraft

Modelling, design and control of middle-size tilt-rotor quadrotor

Multi-body Dynamic Modeling, Simulation and Control Strategy Design of a Y6 Tilt Rotor UAV

SytaB: A Class of Smooth-Transition Hybrid Terrestrial/Aerial Bicopters