Abstract:A BNL type photoinjector was installed in HLS (Hefei Light Source) and commissioning work was carrying out in last months. The dark current was measured when the high power testing of the gun was processed. The quantum efficiency (QE) of the photocathode was measured and studied, the main parameters of beam quality such as electric charge, transverse emittance and energy were measured and presented in this paper. DESCRIPTION OF THE PHOTOINJECTOR The gun is a BNL type S-band normal conducting 1.6 cell cavity with copper cathode, which is nested in a compensation solenoid. The distance between the cathode and the edge of solenoid is 10cm. Fig.1 is the layout of the photoinjector in HLS. The YAG screens is used to imFigure 1: Layout of the photoinjector age the beam profile. Multi-slits is set at the distance of 55cm downstream from the cathode for transverse emittance measurement. The FCT and ICT are used to measure the current signal of the electron beam, the beam charge can be calculated by integrating the current signal. The energy measurement is achieved by a dipole and a YAG screen associate with a camera. As a key component of the system, the drive laser is consist of laser oscillator, regenerative amplifier and harmonic generation crystals. The laser pulse generated from the amplifier is 1047 nm wavelength, 8.3 ps (FWHM) pulse with 10 Hz repeat rate. Through the second and fourth harmonic generation crystals, 262 nm UV laser is gained. The performance of the laser system was measured and the optical transport line for oblique incidence at the cathode was also designed[1]. The high precise phase synchronization system is also a critical requirement for the normal operation of the injector. A timing stabilizer is used to synchronize the 102 MHz laser oscillator signal and the rf signal, the ∗Work supported by second phase of ”985” project † hezhg@mail.ustc.edu.cn precision is achieved about 100 fs . 2856 MHz signal is acquired by the 28th frequency multiplier and sent to the high power RF system. HIGH POWER TESTING OF THE GUN To get the gun into normal operation, conditioning work was done. After hundred hours continuous conditioning, almost 10 MW RF power at the exit of the klystron was achieved. Fig.2 showed the RF power at different high voltage settings of the power supply of the klystron. Figure 2: RF power at different high voltage settings Whereafter, the dark current was also measured, as shown in Fig.3. To collect all of the electron current, the magnetic field strength of the solenoid should be tuned with the changing of the RF power. Figure 3: Dark current Vs magnetic field strength of the solenoid at different RF power Proceedings of FEL2011, Shanghai, China WEPA01 FEL Technology ISBN 978-3-95450-117-5 331 C op yr ig ht c ○ 20 12 by th e re sp ec tiv e au th or s/ C C B Y 3. 0 — cc C re at iv e C om m on sA tt ri bu tio n 3. 0 (C C B Y 3. 0)

Experimental demonstration of dark current mitigation by an over-inserted plug in a normal conducting VHF gun

Design, Fabrication, and Beam Commissioning of a 216.667 MHz Continuous-Wave Photocathode Very-High-frequency Electron Gun

Dark Current Imaging Experiment in an L-band RF Gun

In Situ Observation of Dark Current Emission in a High Gradient Rf Photocathode Gun.

High Performance Operation of a Direct-Current and Superconducting Radio-Frequency Combined Photocathode Gun

Development of a High-Gradient X-band RF Gun with Replaceable Field Emission Cathodes for RF Breakdown Studies

An Ultrahigh-Vacuum S-band Photocathode Radio-Frequency Electron Gun

Characteristics of dark current from an S-band rf gun with exchangeable photocathode system

Simulation of Dark Current and Dark Current-Induced Background Photons in the Thomson Scattering X-ray Source

A Double-Frequency Rf Gun for Field Emission

High brightness CW electron beams from Superconducting RF photoemission gun

RF design and high power tests of a new tsinghua photocathode RF GUN

High-brightness Beam Tests of the Very High Frequency Gun at the Advanced Photo-injector EXperiment Test Facility at the Lawrence Berkeley National Laboratory.

Commissioning of a Photoinjector in HLS

Design and Low-Power RF Test of a C-band Cryogenic RF Gun

Dark Current Studies for SwissFEL

Theoretical Research on A Multibeam-Modulated Electron Gun Based on Carbon Nanotube Cold Cathodes

A Cold Cathode Electron Gun Using Convex Carbon Nanotube Emitter

High voltage DC gun for high intensity polarized electron source

Development of an L-band Photocathode RF Gun at Tsinghua University

Recent Progress on the Design of Normal Conducting APEX-II VHF CW Electron Gun